3M 256-02-01 User Instructions - Page 15

Browse online or download pdf User Instructions for Respiratory Product 3M 256-02-01. 3M 256-02-01 18 pages. Portable compressed air filter and regulator panel with carbon monoxide monitor

Print Page

6. Install new two-stage prefilter element by sliding new element over center rod on manifold so

that rod protrudes from end of element and element is squarely seated against manifold with rod

centered in element.

7. Screw end cap retaining nut onto threaded portion of rod until end cap retaining nut is

seated properly against end of prefilter element and element has come solidly against shoulder

in manifold.

8. Apply a light film of petroleum jelly on beveled edge of prefilter bowl assembly and screw

bowl assembly into manifold until tight. NOTE: Be sure O-ring is properly seated in manifold

to prevent cutting O-Ring. HAND TIGHTEN ONLY!

9. Guide drain tube back through hole in bottom of case.

Air Scrubber-Third and Fourth Stages

1. Loosen screw (7) from bracket (8).

2. Loosen five (5) manifold bolts (9) enough to allow the third and fourth stage filter tube

assemblies to move freely.

3. Remove front two (2) corner bolts with washers.

4. Slide out old third (10) and fourth (11) stage filter tube assemblies.

5. Remove old third stage filter cartridge (13) and cap gasket (12) from the third stage aluminum tube.

6. Clean the aluminum tube in mild soap and water and wipe dry.

7. Refill the third stage aluminum tube by sliding the new third stage filter cartridge into the

aluminum tube from the bottom. Make sure that the flow direction arrow on the new third stage

filter cartridge is pointing DOWN for proper operation.

8. Remove sealing label (14) and install new cap gasket on the TOP of the third stage aluminum

filter tube assembly.

9. Slide the new third stage aluminum filter tube assembly into the air scrubber on the inlet side.

10. Remove old fourth stage filter cartridge (15) and cap gasket from the fourth stage

aluminum tube.

11. Clean the aluminum tube in mild soap and water and wipe dry.

12. Refill the fourth stage aluminum tube by sliding the fourth stage filter cartridge into the

aluminum tube from the top. Make sure that the flow direction arrow on the new fourth stage

filter cartridge is pointing UP for proper operation.

13. Remove sealing label and install new cap gasket on the BOTTOM of the fourth stage

aluminum filter tube assembly.

14. Slide the new fourth stage aluminum filter tube assembly into the air scrubber on the outlet side.

15. Tighten manifold bolts in sequence from center outward to 100 inch-pounds (11 Nm). (Fig. 6)

Repeat sequence and torque bolts to 250 inch-pounds (28 Nm). Recheck for proper

torque limit.

16. Tighten screw on bracket to prevent any damage from occurring when transporting the filter and

regulator panel.

Remove any large volumes of oil/water from the supplied air line prior to connecting the system.

Purge air through the system for a minimum of five (5) minutes prior to use of the newly

installed filters.

NOTE: Dispose of used filter cartridges in landfill according to local, state and federal regulations.

netzerotools.com