Clippasafe 108 Instructions Manual - Page 11
Browse online or download pdf Instructions Manual for Indoor Furnishing Clippasafe 108. Clippasafe 108 12 pages. Wooden playpen with base mat
Print Page
7.
Adjust the wall-posts so that they are perpendicular to the wall surface and place the barrier in
the desired position, making sure that the spindles (B) fit into the wall catch (E) and wall cup (F).
It is important that panels are offset to each other by a minimum angle of 30° at all times.
max 60 mm
min 20 mm
8.
On the second wall surface mark the position for the wall fixings (E) & (F).
The top hole for the upper wall catch (E) should be 805mm from the floor. The top hole for the
lower wall cup (F) should be 125mm from the floor. Fix the catch and wall cup using the
appropriate fixings depending on the surface available: wood screws for wooden surfaces,
appropriate wall-plugs and screws for brick / concrete / plaster walls and metal screws for
metal surfaces.
These screws and fixings are not provided.
Use Size 6 (3.5mm diameter) flat headed
countersunk screws of minimum length 25mm.
9.
Finally, attach the barrier to both sets of wall catches and wall cups adjusting the length of
the spindles as necessary. Secure the spindles by tightening the nuts (C) with the spanner (G).
max 60 mm
min 20 mm
805mm
125mm
1x
1x