ASG TLB-PS61 Operation Manual - Page 3
Browse online or download pdf Operation Manual for Power Supply ASG TLB-PS61. ASG TLB-PS61 5 pages.
Print Page
Operating Instructions
•
Please read the operating manual thoroughly and comply with safety regulations
to operate this power supply.
•
Always grasp the plug of the power cord while plugging in or unplugging the
power supply.
•
Secure the power controller to avoid any danger of pulling and dragging the
power cord.
•
Do not keep near oil, chemical materials, or heated objects. Do not damage the
power cord with sharp object.
•
If the power supply overheats or is overloaded with maximum current rating, the
high-speed fuse will cut off the power. If this situation continues, stop operation
immediately and contact ASG for repair.
•
Do not move Forward/Reverse switch or HI/LO button while tool is running
•
Do not disassemble the electric screwdriver or try to repair it yourself. Please
contact ASG for repair
•
When power supply is not in use, please turn the main power switch OFF and
unplug the power supply.
•
The electric frequency will be lower when the voltage is adjusted to Lo or below
32V, so the torque of the electric screwdrivers will only work at the torque scale
rating below 4.
Do not operate this tool without protective earth connected
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
44110-3898
| Phone: (
| Fax: (
| Email: [email protected] | Web: www.asg-jergens.com | Revision Date: 01/03/18
888) 486-6163
216) 481-4519
Grounding Instructions
The tool should be grounded while in use to protect the operator from electric shock.
The tool is equipped with a three-conductor cord and three-prong grounding-type plug
to fit the proper grounding-type receptacle. The green (or green and yellow) conductor
in the cord is the grounding wire. Never connect the green (or green and yellow)
wire to a live terminal.
Green and Yellow
Blue
Brown
Installation Instructions
•
Use the controller voltage specified in this manual.
•
When using a commercial power supply be sure to set up circuit and safety
breakers. You must also properly ground the power supply.
•
The temperature and humidity should be kept at appropriate levels.
•
Do not set up the power supply in a room that has poor ventilation or where it
may be exposed to dust and metallic flakes.
•
Do not put heavy objects on top of power supply.
•
Attach the power supply securely to a flat, stable surface. Make sure that there is
no danger of it falling.
Earth
Neutral
Live
3