ASGCO CHEVRON Installation, Operation & Maintenance Instructions Manual - Page 7

Browse online or download pdf Installation, Operation & Maintenance Instructions Manual for Ultrasonic Jewelry Cleaner ASGCO CHEVRON. ASGCO CHEVRON 12 pages. Belt cleaners

Print Page

Chevron

Installation

ASGCO Mfg., Inc.

5. Burn or drill a 1" diameter hole at each of the "X" points on both chute

walls.

6. Insert a ¾" x 2" long bolt into each of the 1" diameter holes. Be sure to

insert the bolts from the outside of the chute wall, then place a nut and

washer on each bolt from the inside. Only hand tighten the nuts at this

time.

7. Tack weld the heads of each of the bolts on both sides of the chute wall.

When all of the bolt heads have been welded, the Chevron

installation can begin. Start with the last shaft installation and

work forward toward the head pulley.

Install a Chevron mounting bracket on each of the bolts. To do

this, loosen the nut, slide the bracket into position, then snug up

the nut by hand tightening. Be sure that the top of the bracket

(the part with two notches) is facing up as shown.

Position a Chevron shaft on top of the facing mounting brackets.(The

pillow block and bearing are shipped already mounted on the shaft.)

Fasten both pillow blocks to the bracket with 3/8" X 1½" long bolts and

hardware (flat washer, locking washer, and nut). [Don't worry about the

direction of the discs at this point.

Head Pulley

Chevron Mounting Brackets

Chute Walls

Pillow

Conveyor Belt

Block

Chevron Mounting Bracket

Chute Wall

GO TO PAGE 9

CHEVRON