Doka Framax stripping corner I Series Original Operating Instructions - Page 12

Browse online or download pdf Original Operating Instructions for Construction Equipment Doka Framax stripping corner I Series. Doka Framax stripping corner I Series 18 pages.

Print Page
Note:
The couplings on the Hydraulic unit Framax V4 and the
couplings on the pair of hydraulic hoses are colour-
coded.
B
A
9239-206-01
D
A Hydraulic unit Framax V4
B Framax stripping cylinder I
C Pair of hydraulic hoses for Framax stripping cylinder I
D Pair of hydraulic hoses f. stripp. cyl. 5.00m (optional)
Putting the unit into service
Note:
▪
A cordless screwdriver with a battery voltage of at
least 18 V and a rated speed of 1800 rpm is needed
for putting the Hydraulic unit V4 into operation.
▪
Invariably, only one stripping cylinder can be oper-
ated with the Hydraulic unit V4.
➤
Stand with both feet on the footplate.
CAUTION
Wrist injury
➤
After extending or retracting the stripping
cylinder, switch off the cordless screwdriver
and disengage it from the drive!
➤
Insert the cordless screwdriver with the bit (width-
across 8 mm) into the drive.
C
9239-204-02
A Cordless screwdriver 18 V (1800 rotation/min)
B Bit (width-across 8 mm)
C Drive hexagon socket (width-across 8mm)
D Maximum oil level
E Minimum oil level
12
C
A
B
D
E
Original Operating Instructions Framax stripping corner I hydraulic
Stripping the formwork:
NOTICE
If there is not enough oil in the unit, attempting
to extend another stripping cylinder will result
in damage to the unit.
➤
Check the oil level in the oil reservoir!
Before a stripping cylinder is extended, the oil
level must be at least 25 mm above the 'MIN'
mark.
➤
Set the cordless screwdriver to clockwise rotation
and operate it.
Stripping cylinder extends.
9239-204-03
When a stripping cylinder retracts, hydraulic oil
flows back into the oil reservoir.
Closing the formwork:
NOTICE
If there is too much oil in the oil reservoir,
hydraulic oil will overflow from the reservoir
when an attempt is made to retract another
stripping cylinder.
➤
Check the oil level in the oil reservoir!
Before a stripping cylinder is retracted, the oil
level must be at least 25 mm below the 'MAX'
mark.
➤
Set the cordless screwdriver to counter-clockwise
rotation and operate it.
Stripping cylinder retracts.
9239-204-04
999239002 - 07/2018