Asko 1805 FI Installation Instructions Manual - Page 4

Browse online or download pdf Installation Instructions Manual for Dishwasher Asko 1805 FI. Asko 1805 FI 12 pages.

Print Page
Asko 1805 FI Installation Instructions Manual
CORNER INST
CORNER INST
CORNER INST
CORNER INST
CORNER INSTALLA
ALLA
ALLA
ALLATION
ALLA
If the dishwasher is installed in a corner, there must be
a minimum clearance of 2 inches (50 mm) from the
side wall so the door can open.
HOT T T T T W W W W W A A A A A TER SUPPL
HO
HO
TER SUPPL
TER SUPPL
TER SUPPLY Y Y Y Y
HO
HO
TER SUPPL
WARNING! Plumbing connections must comply with
applicable sanitary, safety and plumbing codes in your
area.
The machine should preferably be connected to a hot
water supply. If a cold water supply is used, the washing
times will be longer but the performance will not be
affected.
The hot water supply line should be minimum 3/8" OD
copper tubing. The inlet valve has a 3/8" NPT female
connection.
CONNECTIONS
CONNECTIONS
CONNECTIONS
CONNECTIONS
CONNECTIONS
Compression nut
Inlet valve, 3/8" OD
90° street elbow
Page 4
TION
TION
TION
TION
Compression sleeve
3/8" OD copper
water line
90° compression elbow
3/8" NPT one end
2" clearance
After determining where the water supply line will enter
the dishwasher, drill a 1" access hole and run the line
to the approximate inlet valve location shown in the figure
below. The inlet valve is on the right front of the machine,
so the water line should be placed on the right side.
If you use soft copper line, leave the tube straight out in
the opening to slide the dishwasher in. Bend the tube
into position after the dishwasher is slid into the cabinet
opening.
For service convenience, a shut-off valve (not supplied)
should be installed in the supply line in an easily
accessible location (such as, beneath the sink) or in
the supply line near the dishwasher fill valve.
It is important that the water supply line and the shut-off
valve have a sufficient flow volume. At last 3 gallons (12
liters) per minute must be able to pass through the
line. The water pressure should be 18-176 psi.
WARNING!
In order to prevent heat damage to the inlet valve, all
solder connections must be made before the water
line is connected to the dishwasher.
INST
INST
INSTALLA
INST
INST
ALLATION
ALLA
ALLA
ALLA

(1) Hot water supply

(2) Shut-off valve
(not supplied)
NOTE:
You should only install the number 4 tubing
before you push the machine into position.
Tubing number 5 is to be fitted when the
machine is in position.
TION
TION
TION
TION
(3) Alternate locations
(4) & (5) Tubing