1010music Fxbox 2.0 Quick Start Manual

Browse online or download pdf Quick Start Manual for Control Unit 1010music Fxbox 2.0. 1010music Fxbox 2.0 2 pages.

Print Page

Before You Start

A microSD card must be inserted into fxbox before you

can get started. By default, fxbox takes audio input

from IN1 and IN2, processes the configured effects,

and sends the result to OUT1 and OUT2. The firmware

and all settings are stored on the microSD card.

Apply Effects

When fxbox starts up, it displays the

grid for Chain A of the loaded preset. Activate an effect by doing

one of the following:

Touch a cell on the touch screen to momentarily enable that

•

effect.

Trigger the effect via CV signal by plugging a gate signal

•

into the CV Trigger jack that maps to the effect in the grid.

Set the effect to be always on by setting the

•

all effects have a trigger property.)

Edit the Parameters of an Effect

Touch an effect cell on the

Push the INFO button. You will see effect specific parameters, such as

Adjust a parameter by turning the Control Knob next to it.

Note:

The signal processing chain applies the effects in the order displayed on the grid, from

•

left to right, then top to bottom.

Add or Change an Effect

Touch a cell on the main grid to select it. Touch an empty cell to add a new effect to the

chain.

Press the INFO button to display the parameters screen.

Touch the effect type button in the top row (

effects list, and then touch an effect to select it. The parameters screen changes to match the

effect type.

Note:

Most effects can be used more than once. All effects can only be used a limited number

•

of times, corresponding to the relative processing power needed. An effect will be

disabled in the list if you cannot use more of that effect type.

Select a Preset

From the Main screen, cycle through the list of presets by touching the

either side of the preset name (

To select a preset from the list, touch the preset name at the top of the Main Screen to

display the Presets screen.

Select a preset by scrolling through the list with any of the Control Knobs, and then touching

in the top right corner of the touch screen.

Load

Save Changes to a Preset

Fxbox 2.0 does not automatically save changes as you work. If you change to a different preset or turn

off fxbox, you will lose your work. If you want to keep the changes you made to a preset, you will need to save them:

Press HOME until you see the Main screen.

Touch the preset name at the top of the screen to display the Presets screen.

Touch

to display the Edit Preset Menu.

Edit

Touch

to store your changes to the currently loaded preset, or

Save

9/12/18 2:26 PM

Fxbox 2.0 Quick Start Guide

screen with the effects

Main

Trigger Mode

screen.

Main

in the example on the right) to display the

FILT

in the Main Screen example shown above).

Just Fun 2

property for the effect to

and

Cutoff

Res

and

buttons on

–

to save to a different preset.

Save As

by following the steps below. (Not

Screen

Ma in

P arameters Screen

P resets Screen