1010music Fxbox 2.0 Hızlı Başlangıç Kılavuzu
Kontrol Ünitesi 1010music Fxbox 2.0 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. 1010music Fxbox 2.0 2 sayfaları.
Sayfayı Yazdır
Before You Start
A microSD card must be inserted into fxbox before you
can get started. By default, fxbox takes audio input
from IN1 and IN2, processes the configured effects,
and sends the result to OUT1 and OUT2. The firmware
and all settings are stored on the microSD card.
Apply Effects
When fxbox starts up, it displays the
grid for Chain A of the loaded preset. Activate an effect by doing
one of the following:
Touch a cell on the touch screen to momentarily enable that
•
effect.
Trigger the effect via CV signal by plugging a gate signal
•
into the CV Trigger jack that maps to the effect in the grid.
Set the effect to be always on by setting the
•
all effects have a trigger property.)
Edit the Parameters of an Effect
1.
Touch an effect cell on the
2.
Push the INFO button. You will see effect specific parameters, such as
3.
Adjust a parameter by turning the Control Knob next to it.
Note:
The signal processing chain applies the effects in the order displayed on the grid, from
•
left to right, then top to bottom.
Add or Change an Effect
1.
Touch a cell on the main grid to select it. Touch an empty cell to add a new effect to the
chain.
2.
Press the INFO button to display the parameters screen.
3.
Touch the effect type button in the top row (
effects list, and then touch an effect to select it. The parameters screen changes to match the
effect type.
Note:
Most effects can be used more than once. All effects can only be used a limited number
•
of times, corresponding to the relative processing power needed. An effect will be
disabled in the list if you cannot use more of that effect type.
Select a Preset
1.
From the Main screen, cycle through the list of presets by touching the
either side of the preset name (
2.
To select a preset from the list, touch the preset name at the top of the Main Screen to
display the Presets screen.
3.
Select a preset by scrolling through the list with any of the Control Knobs, and then touching
in the top right corner of the touch screen.
Load
Save Changes to a Preset
Fxbox 2.0 does not automatically save changes as you work. If you change to a different preset or turn
off fxbox, you will lose your work. If you want to keep the changes you made to a preset, you will need to save them:
1.
Press HOME until you see the Main screen.
2.
Touch the preset name at the top of the screen to display the Presets screen.
3.
Touch
to display the Edit Preset Menu.
Edit
4.
Touch
to store your changes to the currently loaded preset, or
Save
9/12/18 2:26 PM
Fxbox 2.0 Quick Start Guide
screen with the effects
Main
Trigger Mode
screen.
Main
in the example on the right) to display the
FILT
in the Main Screen example shown above).
Just Fun 2
property for the effect to
ON
and
.
Cutoff
Res
and
buttons on
–
+
to save to a different preset.
Save As
by following the steps below. (Not
Screen
Ma in
P arameters Screen
P resets Screen
Copyright 1010music LLC 2018