AMC XIA150e Handleiding voor installatie en gebruik - Pagina 8

Blader online of download pdf Handleiding voor installatie en gebruik voor {categorie_naam} AMC XIA150e. AMC XIA150e 17 pagina's. Stereo integrated amplifier

Pagina afdrukken

9. LOUDSPEAKERS

Your AMC amplifier is designed to drive

loud-speakers with a nominal impedance

of 4-8 ohms.

LOUDSPEAKER CONNECTIONS

The loudspeaker output terminals will

accept 4mm (banana) plugs, spade

connectors, pin connectors or bare wires.

Connect the negative side(usually black)

of your left hand loudspeaker lead to the

black terminal of the two terminals

marked "L" on the rear of your amplifier.

The other side of your left hand speaker

lead (the positive side or red) should be

connected to the red terminal marked "L".

Repeat this operation for the right hand

loudspeaker.

Your AMC amplifier is capable of

generating high peak currents, so all

connections must be checked to avoid

inadvertent short circuits and to ensure a

good clean contact.

UNDER NO CIRCUMSTANCES SHOULD

THE OUTPUTS BE SHORTED TOGETHER.

Such action will damage output circuitry

and is not covered by guarantee.

10. PHONO GROUND TERMINAL

The Ground Terminal is for you to

connect ground wire of your turntable in

order to eliminate possible interference

and hum loop for best possible sound

quality.

11. USB (OPTION)

The USB feature is optional.

The USB connector is for connecting to

computer, other equipments with USB,

LAN and so the internet.

12. AMC CARD (OPTION)

13. RS232 (OPTION)

XIA100e/XIA150e can be hooked to a

control system through the AMC Card,

RS232 or Ethernet connector to accept

commands from your system controller.

For details of RS-232 commands, please

refer to the RS-232 appendix.

14. ETHERNET (OPTION)

15. AC RECEPTACLE

The AC RECEPTACLE is for you to plug

in with power cord attached in the

packing or you can plug in with other

power cord with your preferences.

H E A T S I N K / V E N T I L A T I O N

REQUIREMENTS

The heat produced by your AMC amplifier

during normal operation is dissipated by

an internal finned heatsink. It is perfectly

normal for your amplifier to becomes

quite warm and to radiate heat when in

use, especially if it is run near full power.

However, if it becomes too hot to touch,

switch off at once and contact your

dealer.

It is very important that there is adequate

ventilation for the whole of the amplifier.

Do not place the unit on a rug or other

soft surface that it could sink into,

obstructing the air inlets on its underside,

and take care not to obstruct the outlet

grille on the top cover.