AMC XIA150e Manual de instruções de instalação e funcionamento - Página 8

Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Amplificador AMC XIA150e. AMC XIA150e 17 páginas. Stereo integrated amplifier

9. LOUDSPEAKERS
Your AMC amplifier is designed to drive
loud-speakers with a nominal impedance
of 4-8 ohms.
LOUDSPEAKER CONNECTIONS
The loudspeaker output terminals will
accept 4mm (banana) plugs, spade
connectors, pin connectors or bare wires.
Connect the negative side(usually black)
of your left hand loudspeaker lead to the
black terminal of the two terminals
marked "L" on the rear of your amplifier.
The other side of your left hand speaker
lead (the positive side or red) should be
connected to the red terminal marked "L".
Repeat this operation for the right hand
loudspeaker.
Your AMC amplifier is capable of
generating high peak currents, so all
connections must be checked to avoid
inadvertent short circuits and to ensure a
good clean contact.
UNDER NO CIRCUMSTANCES SHOULD
THE OUTPUTS BE SHORTED TOGETHER.
Such action will damage output circuitry
and is not covered by guarantee.
10. PHONO GROUND TERMINAL
The Ground Terminal is for you to
connect ground wire of your turntable in
order to eliminate possible interference
and hum loop for best possible sound
quality.
11. USB (OPTION)
The USB feature is optional.
The USB connector is for connecting to
computer, other equipments with USB,
LAN and so the internet.
12. AMC CARD (OPTION)
13. RS232 (OPTION)
XIA100e/XIA150e can be hooked to a
control system through the AMC Card,
RS232 or Ethernet connector to accept
commands from your system controller.
For details of RS-232 commands, please
refer to the RS-232 appendix.
14. ETHERNET (OPTION)
15. AC RECEPTACLE
The AC RECEPTACLE is for you to plug
in with power cord attached in the
packing or you can plug in with other
power cord with your preferences.
H E A T S I N K / V E N T I L A T I O N
REQUIREMENTS
The heat produced by your AMC amplifier
during normal operation is dissipated by
an internal finned heatsink. It is perfectly
normal for your amplifier to becomes
quite warm and to radiate heat when in
use, especially if it is run near full power.
However, if it becomes too hot to touch,
switch off at once and contact your
dealer.
It is very important that there is adequate
ventilation for the whole of the amplifier.
Do not place the unit on a rug or other
soft surface that it could sink into,
obstructing the air inlets on its underside,
and take care not to obstruct the outlet
grille on the top cover.
6