AMC IF16L Installatiehandleiding - Pagina 8

Blader online of download pdf Installatiehandleiding voor {categorie_naam} AMC IF16L. AMC IF16L 9 pagina's. Pir curtain lens intrusion detector

Fixed base rearslide the cable through the holes selected, secure the board in its housing interlo-

cking and fix the cables into the appropriate terminals.

In the figure at the end of manual, you can see different types of installation, in the center of the

window or on a side. The drawings are for guidance only so you should always test the sensor.

5. WARM UP AND OPERATION

At start up the sensor needs a warm up time, this time is about 40 '. There will be fewer violations

during this time is the faster entry into operational mode.

Operating without options: when the sensor is ready ,after the first violation, the waiting time for

second violation is a few seconds (5 sec. max). Note: If the buzzer is activated you will have 2

different sounds depending on the direction of the violation.

Operating with presence lamp in ON mode (dip 6): when there is a violation of the sensor trig in

alarm and turn on the lamp. The duration time of lamp is 40 '. During the lighting of the lamp, sensor

remains disabled for 20 seconds to re-calibrate the thresholds. After this time the sensor is still ready

(with lamp in ON mode). Each new violation prolong the time of the lamp for 40 ', recovery time by

the alarm is 10 seconds. Thus the sensor works correctly even with the lamp on. When the lamp is

turned off you will have a new calibration of the duration of 20 seconds. In case of violations during

the calibration time, after 30 seconds the sensor trig in alarm. note: the violation must be continuous

to block the calibration procedure.

Operation with delay times (dip 4 - 5): with the delay time set, you can access protected air wi-

thout giving alarm, so you can access the system without disarm. After this time, the sensor resets

without giving alarm. If after the set time for more 20seconds, the sensor detects movement still

give alarm.

operation with directional system (dip 7 - 8): activating the directional system is possible to

make sure that the sensor gives an alarm only in the desired direction. This function can be used

for installation of doors and windows. After a violation in the permitted direction, the sensor will

activate a time of 2 minutes within which it is possible to come back from the direction of alarm. In

this way it is possible to go out on a terrace without giving alarm, or look out the window with the

system armed.

Note 10 seconds before the end of time the buzzer will sound.

LAMP: To negative for turn on the power led

AP: Tamper protection COM : common

negative NC : alarm contact(N.C.) SUPPLY

: pwer supply (13.8Vcc)

IF16L

installation instructions