Domus MURO-30S-B-W Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Domus MURO-30S-B-W. Domus MURO-30S-B-W 4 pagina's. Spotlight with sensor

Domus MURO-30S-B-W Installatiehandleiding
1. Refit the Cable Anchorage
2. Fit main body onto the Backcover. Adjusting the light direction you desired, then tighten the screws.
3. Switch the main power on.
252mm
2x
6x27mm PA4x30mm
Notes for electrician
• The LED lamp should be wired to its own light switch.
• Do not interconnect with other lights on the same switch.
• Earth connection must be required.
• Multiple (More than one) Muro fittings must not be wired to a
separate sensor.
• Multiple Muro Fittings cannot be wired to a single switching point.
Understanding the controls
Adjusting the duration time:
The length of time that remains switched on after activation can be
adjusted from (10±5) seconds to (4±1) minutes. Rotating the TIME
knob + to - will reduce the duration time.
Note: Once the light has been triggered by the PIR sensor any subsequent detection will start the timed period
again from the beginning.
187mm
2x
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600
OFF
|
Fax: 02 9554 9433
|
www.domuslighting.com
Installation Manual
Ø6mm
30mm
ON
TIME
SENS
LUX
Control Knob