Ekinex EK-HE1-TP Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Ekinex EK-HE1-TP. Ekinex EK-HE1-TP 5 pagina's. Actuator / controller for electrothermal actuators

Pagina afdrukken

Technical data

Power supply

• 30 Vdc from bus (electronics)

• 230 Vac 50/60 Hz or 24 Vac (loads)

• Current consumption from bus < 30 mA

• Power consumption from bus 720 mW

TRIAC outputs

• Nr: 8 independent (2-pipe systems)

4 coupled (4-pipe systems)

• Max current I

: 2(1) A

max

• Max 4 electrothermal actuators in parallel for each

TRIAC output 0,5(0,3) A max

Environmental conditions

• Operating temperature: 0 ... + 55°C

• Storage temperature: - 25 ... + 55°C

• Transport temperature: - 25 ... + 70°C

• Relative humidity: 95% not condensing)

Note. For controlling loads different than electro-

thermal drives and servomotors for zone valve or

loads with rated current higher than the maximum

current, interface relays must be used.

Switching, display and connection elements

The device is provided with a membrane front keypad

with signalling LEDs and pushbuttons, programming LED

and pushbutton, a terminal for connecting the KNX bus

line and screw terminals for connecting the power supply

and the outputs.

bus KNX

1) Programming pushbutton

2) Programming LED

3) Terminal block for KNX bus line

4) Field for physical address

Membrane keypad

5) Signalling LED for xy channel (x = 1 ... 4; y = A, B)

6) Pushbutton for manual operation of xy channel (x = 1 ... 4; y = A, B)

7) Pushbutton for switching manual / automatic operation

8) LED for signalling manual / automatic operation mode

Area

Line

Dev.

Note. To switch between manual mode and auto-

matic mode (and vice versa), press the appropriate

pushbutton for a time > 3 s.

Signalling LED

LED

Status

Single channel

off

Group of 4

slow blinking

channels

(1 s)

fast blinking

Single channel

(1 / 4 s)

Pushbutton ma-

nual / automatic

off

*) To acknowledge a short-circuit alarm, keep pressed the correspon-

ding channel pushbutton for a time > 3 s.

Note. Use only servomotors for zone valve equip-

ped with stroke-end microswitches.

Terminal blocks for power supply and outputs

Nr.

Sign

Connection

TRIAC output for valve drive

6, 14

Power supply phase (230 Vac or 24 Vac)

7, 8, 15, 16

Power supply neutral (230 Vac or 24 Vac)

Mounting

The device has degree of protection IP20, and is there-

fore suitable for use in dry interior rooms. The housing

is made for rail mounting according to EN 60715 in bo-

ards or cabinets for electrical distribution. The correct

mounting is when the KNX bus terminal is located at the

bottom. When installing be sure to leave accessible only

the front panel; all other sides must not be accessible.

For the installation of the device on the rail proceed as

follows:

• with the aid of a tool bring the locking device in the fully

lowered position (1);

• place the upper edge of the rear inner profile on the

upper edge of the rail (2);

Meaning

Presence of power supply

Absence of power supply

Absence of power supply for a

4-channels group

Short-circuit alarm*

Manual mode active

Automatic mode active