Donovan Hammer II Gebruikershandleiding - Pagina 8
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Donovan Hammer II. Donovan Hammer II 20 pagina's. Arm system for belly dumps, end dumps, dump bodies & pups
Pagina afdrukkenFront Drive - Side Plates - continued
STEP 5: Remove tarp axle, cut squarely at mark and deburr
cut end. Drill 5/16" hole 5/8" from cut end of axle,
aligning hole as shown.
5/16"
drill
STEP 6A: Electric motor. Insert stub shaft through passenger
side tarp axle bracket and align tarp axle between
brackets. On driver side, insert motor shaft through
bracket and into tarp axle. Fasten motor to bracket
with supplied screws.
screws supplied
/
w
motor
driver side
STEP 6B: Manual crank. On driver side, loosely fasten flange
bearing to bracket with screws
. Insert stub shaft through passenger side tarp axle
L
bracket and align tarp axle between brackets. Insert
sprocket shaft through bearing and into tarp axle.
tarp axle
P
C
driver side
5
hole
tarp axle
electric
&
motor
cover
, washers
C
P
L
P
collar
shaft
sprocket
STEP 7A: Electric system. Slide bearing assembly over stub
shaft and fasten to tarp axle bracket with screws
washers
STEP 7B: Manual system. Slide bearing assembly over stub
shaft and loosely fasten to bearing plate with screws
H
sprocket location, then tighten fasteners.
2-1/4"
driver side
STEP 8: Tighten set screw on ball bearing.
and nuts
and nuts
.
Q
M
, washers
and nuts
. On driver side, adjust
Q
M
H
bearing
passenger side
passenger side
P/N 1809533 Rev. B
,
H
shaft
extension
bearing
Q
M
plate
tighten
set screw