Dontek AQUASMART 5 SV Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dontek AQUASMART 5 SV. Dontek AQUASMART 5 SV 13 pagina's.

The pool sensor must be fitted into the heating circuit, as close to the pool as practical,

preferably in a position out of direct sunlight. It is recommended that a 14.5mm hole

be drilled in the side of the PVC pipe, not the top of the pipe where water will collect.

This can be carried out using a Dontek PD01 grinding drill or a pilot hole drilled, then a

14.0mm drill-bit spinning in a counter clockwise direction to minimize the chance of

POOL

shattering pipe.

SENSOR

Insert the grommet into the pipe and gently push in the sensor barb. Ideally ~30cm of

the cable from the sensor should be tied to the shaded side of the pipe to prevent

extreme ambient conditions leeching into the sensor via the copper in the cable. The

blue sensor plug is to be fitted to the plug socket marked POOL.

The roof sensor must be fitted into a small piece of collector material away from the

main collector but on the same aspect, preferably no more than 50cm from the roof

gutter (for ease of sensor replacement). If required, the roof sensor can be on a

ROOF

different roof to the solar collector as long as the alignment to the sun is similar to the

SENSOR

solar collector. For encapsulated collector panels, use the manufacturer's instructions

for roof sensor placement. The red sensor plug is to be fitted to the plug socket

marked ROOF.

All excess cable must be removed; coils of cable are not permitted under any

circumstances and must not be tied to 240V wiring. If the cable is to be extended with

SENSOR

non-genuine cable a size of 14/020 should be used. Any cable joins should be soldered.

Heat shrink is to be used over soldered joints to eliminate moisture ingress, and the

NOTES

cable end is to be refitted to the plug sockets. Once cables have been correctly fitted

the unit can be then turned on.

BASE PLATE

Circulation Pump plugs

in here.

AQUASMART 5 SV v1.4

Solar Booster Pump

plugs in here.

Valve Actuator

plugs in here.

3 Pin Port

Roof Sensor

Pool Sensor

plugs in here.

Heater Interlock

cable plugs in here

2 Pin Port