DoorHan Swing-2500 Installatie- en bedieningshandleiding - Pagina 9
Blader online of download pdf Installatie- en bedieningshandleiding voor {categorie_naam} DoorHan Swing-2500. DoorHan Swing-2500 12 pagina's.
Pagina afdrukken5. emergenCy release operation
Emergency release is used to release the motor in case of power cut. To release the motor, turn the handle by 90 degrees.
Warning! Before releasing (linking) the operator, disconnect power supply.
unlock
Warning! After the operator was installed check the emergency release for correct operation. use of the release may
cause uncontrolled movement of the driven part due to mechanical failures or an out-of-balance condition.
6. maintenanCe
The Swing-2500 automatic system does not require any special servicing.
Repairs may be carried out only by a qualified technician trained and certified at an authorized DoorHan centre.
B e sure that after completion of installation the installer has shown the user how to release the door in case of emergency
and has given instructions on proper operation and maintenance of the automated system.
When carrying out maintenance, it is recommended to use DoorHan original spare parts.
carry out maintenance of the automatic system at least every six months.
Regularly check if the door is properly balanced and moves smoothly when automatically operated.
R egularly check if the extreme positions of door travel are properly adjusted and safety devices are in good working
condition.
I n case of power failure you may need to restore operator's settings. Once the power supply is restored, check the
automatic system for proper operation. If the operator settings have changed reprogram them following the instructions
given in the corresponding paragraph of this manual (pay special warning to Operation time programming).
In case of power failure the door will stop. As soon as power supply is restored you can control the operator as usual.
After expiration of life time, the item shall be delivered in a specialized disposal point!
If you have lost this Manual, you may request for the duplicate copy to the following address: Kralovsky VRcH 2018,
Kadan, 43201, czech Republic, or by e m ail: [email protected].
T he producer (DoorHan) does not supervise the installation of operators, or carry out their maintenance, thus DoorHan
cannot be held liable for safety of installation, operation and maintenance of the equipment.
7. troUBleshooting
symptom
Operator does not run
Operator stops suddenly
The gate does not open or close completely
Lock
possible reason
power is off
Obstruction at gate's movement
Bad wiring connection
Operator is released
Thermal protection is active
Wrong operator programming
eMerGency release OperatIOn
Lock
unlock
solution
Make sure, that the power is on
Remove the obstruction
check reliability of electric wiring connection
Engage the operator
Let the operator cool
Reprogram the operator
9