Astria Rhapsody42TEN Handleiding voor installatie-instructies - Pagina 3

Blader online of download pdf Handleiding voor installatie-instructies voor {categorie_naam} Astria Rhapsody42TEN. Astria Rhapsody42TEN 10 pagina's. 42- and 54-inch linear direct vent gas fireplaces

Pagina afdrukken

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

INSTALLATION INSTRUCTIONS

Complete all steps in the order shown, including the installation

of optional accessories (if applicable).

Remove bezel (from optional bezel kit), if installed

1. Gently pull out the lower edge of the bezel to detach it from

the lower edge of the glass door assembly.

2. Swing the lower edge of the bezel away from the door, then

lift up to unhook the bezel upper flange from the top edge

of the glass door assembly (Figure 2).

Bezel Lower Flange

Figure 2: Removing the bezel

Remove glass door assembly

1. Remove the three (3) screws securing the lower edge of the

glass door assembly to the fireplace (Figure 3).

2. Grasp the glass door assembly by the sides, swing the lower

edge out, and then lift up to unhook it from the fireplace.

NOTE: Take care not to damage the glass.

3. Set aside the screws and glass door assembly in a secure

location for later reinstallation.

Glass Door Assembly

Figure 3: Removing the glass door assembly

Bezel Upper

Flange

Glass Door

Assembly

[CROSS-SECTION]

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Remove baffle from fireplace floor, if installed

1. If unpacking the fireplace for the first time, remove the

baffle from fireplace floor, where it is packed for shipping

(Figure 4).

2. Set aside the baffle in a secure location for later installation.

Baffle (as shipped)

Figure 4: Removing the baffle

Access the control compartment

1. Remove the two (2) screws securing the burner assembly

to the burner brackets. Carefully slide the burner to the left,

to clear the venturi from the orifice. Rotate the burner to

release the air shutter adjustment rod from the air shutter

lever (Figure 5). Lift and remove the burner assembly,

and set aside the screws and burner assembly in a secure

location for later reinstallation.

Air Shutter Rod

Figure 5: Releasing the air shutter adjustment rod

2. Remove the control compartment access door and gasket

by removing the twelve (12) screws securing it. Set

aside the screws, door, and gasket for later reinstallation

(Figure 6).