Astria Rhapsody42TEN Manual de instruções de instalação - Página 3
Procurar online ou descarregar pdf Manual de instruções de instalação para Lareira de interior Astria Rhapsody42TEN. Astria Rhapsody42TEN 10 páginas. 42- and 54-inch linear direct vent gas fireplaces
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
INSTALLATION INSTRUCTIONS
Complete all steps in the order shown, including the installation
of optional accessories (if applicable).
Remove bezel (from optional bezel kit), if installed
1. Gently pull out the lower edge of the bezel to detach it from
the lower edge of the glass door assembly.
2. Swing the lower edge of the bezel away from the door, then
lift up to unhook the bezel upper flange from the top edge
of the glass door assembly (Figure 2).
Bezel Lower Flange
Figure 2: Removing the bezel
Remove glass door assembly
1. Remove the three (3) screws securing the lower edge of the
glass door assembly to the fireplace (Figure 3).
2. Grasp the glass door assembly by the sides, swing the lower
edge out, and then lift up to unhook it from the fireplace.
NOTE: Take care not to damage the glass.
3. Set aside the screws and glass door assembly in a secure
location for later reinstallation.
Glass Door Assembly
Figure 3: Removing the glass door assembly
Bezel Upper
Flange
Glass Door
Assembly
[CROSS-SECTION]
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Remove baffle from fireplace floor, if installed
1. If unpacking the fireplace for the first time, remove the
baffle from fireplace floor, where it is packed for shipping
(Figure 4).
2. Set aside the baffle in a secure location for later installation.
Baffle (as shipped)
Figure 4: Removing the baffle
Access the control compartment
1. Remove the two (2) screws securing the burner assembly
to the burner brackets. Carefully slide the burner to the left,
to clear the venturi from the orifice. Rotate the burner to
release the air shutter adjustment rod from the air shutter
lever (Figure 5). Lift and remove the burner assembly,
and set aside the screws and burner assembly in a secure
location for later reinstallation.
Air Shutter Rod
Figure 5: Releasing the air shutter adjustment rod
2. Remove the control compartment access door and gasket
by removing the twelve (12) screws securing it. Set
aside the screws, door, and gasket for later reinstallation
(Figure 6).
3