Akw AKW23116 Installatie, onderhoud en gebruikersinstructies - Pagina 9

Blader online of download pdf Installatie, onderhoud en gebruikersinstructies voor {categorie_naam} Akw AKW23116. Akw AKW23116 16 pagina's. Basin mixer valve

Pagina afdrukken

Commissioning

Maximum Temperature

The maximum blend temperature obtainable by the user should be limited to

prevent accidental selection of a temperature that is too hot.

The T301 tap is fully performance tested and the maximum temperature is preset

to 41°C under ideal installation conditions at the factory. Site conditions and

personal preference may dictate that the maximum temperature has to be reset

following installation.

Maximum Temperature Setting

Make sure that an adequate supply of hot water is available at the hot inlet of the

T301.

The minimum temperature of the hot water must be at least 10°C above the

desired blend. However, during resetting this should be close to the typical storage

maximum to offset the possibility of any blend shift due to fluctuating supply

temperatures.

Make sure that both inlet isolating valves are fully open.

Temperatures should always be measured using a thermometer with proven

accuracy.

Guide to maximum stabilised temperatures recorded during site tests (Table 3)

Wash Basin

Commissioning must be carried out in accordance with these

instructions, and must be conducted by designated, qualified

and competent personnel.

Application

Mixed Temperature °C