Canon XL 1 Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Canon XL 1. Canon XL 1 26 pagina's. Camcorder
Ook voor Canon XL 1: Brochure (8 pagina's), Specificaties (1 pagina's), Instructies (2 pagina's), Brochure & specificaties (8 pagina's), Gebruikershandleiding (9 pagina's), Handmatig (9 pagina's)

Normally, the camera sets the audio recording level automatically, as long as

the REC LEVEL switch is set to A. You can set the recording level manually:

a. Slide the REC LEVEL switch of the AUDIO 1/Mic controls to M.

(MANU appears in the audio LCD panel).

b. Turn the LEVEL dial to adjust the recording level and BALANCE dial

to adjust the balance between the 2 inputs. Check the levels in the

audio LCD panel. Note: you can not adjust the volume level

independently for the left and right channels. We recommend keeping

the level below the 12 point index mark, and monitoring the sound

using headphones. You can adjust the headphone volume by rotating

the PHONES LEVEL dial.

Audio 1 Input for Two Channel Recording (Stereo 1) using the RCA jacks, where

the sound source is a VCR, CD or other input device using the RCA terminals on the

back of the XL1, instead of the microphone mini jack.

1. Open the Camera Menu.

Select AUDIO MODE and choose one of the following modes:

a. 16-bit 48KHz 2 channel (for the highest sound quality) Note: the 16-bit

mode contains only Stereo 1 sound. There is no Stereo 2 in this mode.

b. 12-bit Stereo 1 (32kHz, 2 out of 4 total channels) for recording on 2

channels (Stereo 1), leaving 2 channels (Stereo 2) free for you to add

new sound at a later date using a DV VCR. NOTE: you cannot add

new sound to a tape using the XL1 camcorder.

Close the menu. The name of your chosen mode is displayed in the viewfinder

and main LCD panel. It is not necessary to set AUDIO 1 to MIC on the menu.

2. Slide the INPUT SELECT switch to AUDIO 1. This assigns the AUDIO 1

RCA jacks as the source for the audio input.

3. Open the Camera Menu and select AUDIO 1 INPUT, then choose LINE to

record sound from a VCR, CD or other line-in devices.

4. Select the recording level method.

Normally, the camera sets the audio recording level automatically, as long as

the REC LEVEL switch is set to A. You can set the recording level manually:

a. Slide the REC LEVEL switch of the AUDIO 1/Mic controls to M.

(MANU appears in the audio LCD panel).