Canon XL 1 사용자 설명서 - 페이지 13

{카테고리_이름} Canon XL 1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon XL 1 26 페이지. Camcorder
Canon XL 1에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 사양 (1 페이지), 지침 (2 페이지), 브로셔 및 사양 (8 페이지), 사용자 설명서 (9 페이지), 매뉴얼 (9 페이지)

페이지 인쇄
Canon XL 1 사용자 설명서
Normally, the camera sets the audio recording level automatically, as long as
the REC LEVEL switch is set to A. You can set the recording level manually:
a. Slide the REC LEVEL switch of the AUDIO 1/Mic controls to M.
(MANU appears in the audio LCD panel).
b. Turn the LEVEL dial to adjust the recording level and BALANCE dial
to adjust the balance between the 2 inputs. Check the levels in the
audio LCD panel. Note: you can not adjust the volume level
independently for the left and right channels. We recommend keeping
the level below the 12 point index mark, and monitoring the sound
using headphones. You can adjust the headphone volume by rotating
the PHONES LEVEL dial.
Audio 1 Input for Two Channel Recording (Stereo 1) using the RCA jacks, where
the sound source is a VCR, CD or other input device using the RCA terminals on the
back of the XL1, instead of the microphone mini jack.
1. Open the Camera Menu.
Select AUDIO MODE and choose one of the following modes:
a. 16-bit 48KHz 2 channel (for the highest sound quality) Note: the 16-bit
mode contains only Stereo 1 sound. There is no Stereo 2 in this mode.
b. 12-bit Stereo 1 (32kHz, 2 out of 4 total channels) for recording on 2
channels (Stereo 1), leaving 2 channels (Stereo 2) free for you to add
new sound at a later date using a DV VCR. NOTE: you cannot add
new sound to a tape using the XL1 camcorder.
Close the menu. The name of your chosen mode is displayed in the viewfinder
and main LCD panel. It is not necessary to set AUDIO 1 to MIC on the menu.
2. Slide the INPUT SELECT switch to AUDIO 1. This assigns the AUDIO 1
RCA jacks as the source for the audio input.
3. Open the Camera Menu and select AUDIO 1 INPUT, then choose LINE to
record sound from a VCR, CD or other line-in devices.
4. Select the recording level method.
Normally, the camera sets the audio recording level automatically, as long as
the REC LEVEL switch is set to A. You can set the recording level manually:
a. Slide the REC LEVEL switch of the AUDIO 1/Mic controls to M.
(MANU appears in the audio LCD panel).
13