Canon XL 1 사용자 설명서 - 페이지 14

{카테고리_이름} Canon XL 1에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon XL 1 26 페이지. Camcorder
Canon XL 1에 대해서도 마찬가지입니다: 브로셔 (8 페이지), 사양 (1 페이지), 지침 (2 페이지), 브로셔 및 사양 (8 페이지), 사용자 설명서 (9 페이지), 매뉴얼 (9 페이지)

페이지 인쇄

b. Turn the LEVEL dial to adjust the recording level and BALANCE dial

to adjust the balance between the two inputs. Check the levels in the

audio LCD panel. Note: you cannot adjust the volume level

independently for the left and right channels. We recommend keeping

the level below the 12 point index mark, and monitoring the sound

using headphones. You can adjust the headphone volume by rotating

the PHONES LEVEL dial.

Audio 1 Input for Two Channel Recording (Stereo 1) using the RCA jacks, where

the sound sources are XLR type microphones attached via the MA-100 Microphone

Adapter/Shoulder Pad which contains 2 XLR inputs (L and R). The MA-100 can be

plugged into the AUDIO 1 RCA terminals on the back of the camcorder, or AUDIO 2

RCA terminals on the right side of the grip handle.

1. Open the Camera Menu.

Select AUDIO MODE and choose one of the following modes:

a. 16-bit 48KHz 2 channel (for the highest sound quality) Note: the 16-bit

mode contains only Stereo 1 sound. There is no Stereo 2 in this mode.

b. 12-bit Stereo 1 (32kHz, 2 out of 4 total channels) for recording on 2

channels (Stereo 1), leaving 2 channels (Stereo 2) free for you to add

new sound at a later date using a DV VCR. NOTE: you cannot add

new sound to a tape using the XL1 camcorder.

Close the menu. Chosen mode is displayed in the finder and main LCD.

2. If you are using the AUDIO 1 inputs, slide the INPUT SELECT switch to

AUDIO 1. This assigns the AUDIO 1 RCA jacks (on the back of the XL1) as

the source for the audio input, and disables the supplied microphone.

3. Open the Camera Menu and select AUDIO 1 INPUT, then choose:

a. MIC ATT 20: recording high-level sound using a mic

b. MIC: to record sound using an XLR microphone

4. Select the recording level method. Normally, the camera sets the audio

recording level automatically, as long as the REC LEVEL switch is set to A

(automatic). You can set the recording level manually:

a. Slide the REC LEVEL switch of the AUDIO 1/Mic controls to M.

(MANU appears in the audio LCD panel).