Dafra DRPB48 Bedieningshandleiding - Pagina 2

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Dafra DRPB48. Dafra DRPB48 10 pagina's. Pneumatic blind rivet setting tool

DRPB48 Operation Manual

GETTING STARTED

Please refer to the TOOL EXPLOSIVE ILLUSTRATION and the PARTS LIST in this manual in

order to have a good understanding of the tool parts described. The descriptions of the tool parts

appear in this manual are in italics with the parts position numbers corresponding to the tool

explosive illustration.

1) This pneumatic powered tool should be used with a compressed air supply.

recommended to use an air hose with a diameter bigger than 8mm.

2) Before connecting the tool to the compressed air supply, check that the compressed air

pressure is within the specified range of between 0.5Mpa ~ 0.7Mpa. Once the air pressure

has been confirmed, connect the air hose adaptor onto the tool air adaptor (#47). The air

adaptor comes in different versions in different countries. Normally the tools are equipped

with the correct version for your country as default, however, if the air adaptor you have

received does is incorrect, please contact the tool distributor(s).

3) Change and use correct nosepiece (#1) according to the size of the rivet to be set. This tool

is equipped with nosepieces 3.0/3.2mm, 4.0mm and 4.8/5.0mm (on the tool) in the kit.

Follow the steps below to change the nosepiece (#1);

a) Remove the air supply hose from air adaptor (#47).

b) Use the wrench (in accessories pack) to remove the nosepiece (#1) from the tool as

below;

c) Select the correct nosepiece in the accessories pack and screw on to the tool, using the

wrench to fix it firmly on the tool.

4) Install the mandrel release protector (in accessories pack) on the back of the tool.

It is