Baumer PAC50H Bedieningshandleiding - Pagina 6

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Baumer PAC50H. Baumer PAC50H 44 pagina's.

General information

Intended use

This product is a precision device and serves the detection of items, objects, or physical mea-

surement variables and the preparation or provision of measured values as electric variables for

the higher-level system.

Unless specifically labeled, this product may not be used in explosive environments.

The product is exclusively intended for use in industrial working environments.

The application range relates to conductible fluids with the following properties:

Conductivity: ≥ 1 μS/cm (+15 µS / -1 µS)

Conductivity: 0 - 1000 mS (+/-15 µS +/-2 %)

Sensor use is only intended for media to which housing material and sensor tip are resistant.

Commissioning

Assembly, installation, and calibration of this product may only be performed by a specialist.

Installation

Only use the fasteners and fastener accessories intended for this product for installation. Out-

puts not in use must not be wired. Unused wires of cable outputs must be insulated. Do not go

below the permissible cable bending radii. Disconnect the system from power before the

product is electrically connected. Use shielded cables to prevent electro-magnetic interference.

If the customer assembles plug connections on shielded cables, then EMC-version plug con-

nections should be used and the cable shield must be connected to the plug housing across a

large surface area.

Disposal (environmental protection)

Used electrical and electronic devices may not be disposed of in household

waste. The product contains valuable raw materials that can be recycled. There-

fore dispose of this product at the appropriate collection point. For additional in-

formation visit www.baumer.com.

Operating Manual

Baumer

PAC50H/S | V1