Amphenol Tempsonics Level Plus LLE Bedieningshandleiding - Pagina 19

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Amphenol Tempsonics Level Plus LLE. Amphenol Tempsonics Level Plus LLE 20 pagina's. Magnetostrictive liquid level transmitters with temposonics technology

Pagina afdrukken

10. Spare Parts

Below are the spare parts list for the LLE that are included as part of

the model number. Please contact Temposonics Technical Support

with any questions.

Stop Collar

7 mm O-ring

10 mm O-ring

7 mm stop collar

10 mm stop collar

Cable

Analog

IO-Link

CANopen

SSI

Process Connection

SAE 5 Bolt

1 " NPT

1,5 " NPT

2 " NPT

2,5 " NPT

3 " NPT

4 " NPT

2 " 150# RF Flange

3 " 150# RF Flange

4 " 150# RF Flange

5 " 150# RF Flange

6 " 150# RF Flange

Fig. 9: Spare parts

11. Interface

11.1 Analog output

The analog output for LLE is either single output or dual output

dependent on the order code. The output codes starting with V are

voltage outputs and the codes starting with A are current outputs. The

first digit is the voltage or current closest to the head and the second

is closet to the tip. For example, A010 4..20mA has the 4mA set point

closest to the head and 20 mA closest to the tip. The analog output

cannot be adjusted.

Part number

562354

562355

562392

562348

Part number

370675

370676

Part number

404205

562349-1

562349-2

562349-3

562349-4

562349-5

562349-3

560465-1

560465-2

560465-3

560465-4

560465-5

11.2 IO-Link output

IO-Link is an open standard according to IEC 61131-9. It is a serial,

bi-directional point-to-point connection for signal transmission and

energy supply. The bi-directional communication enables consistent

communication between sensors and the controller as well as

consistent diagnostic information down to the sensor level. For

additional details on setup please consult the EH IO Link manual

551485 section 5.

The measurement direction of IO Link can be programmed by the

customer. The Parameter Measuring Direction, Index 0x73, can be set

to False to measure from the housing to the tip of the pipe or True to

measure from the tip of the pipe to the housing.

11.3 SSI output

The SSI output is available as either 24 or 25 bit, Binary or Gray code,

and 0.1 mm resolution. The measurement direction is set to measure

up from the tip of the pipe.

11.4 CANopen output

CANbus (Controller Area Network) is designed for high-speed data

exchange at machine level. CAN is a vendor independent open

fieldbus system, based on standard ISO 11898. CAN specifies the

functional and technical parameters with which the intelligent digital

automation devices can be networked via a master-slave serial link

by using a communication profile. Protocol architecture of functional

and applications data is oriented to the OSI reference model (ISO

7498). Bus technology is administrated and developed by the user

organisation CiA (CAN in Automation)

The CANOpen output of the LLE is avaialbe with or without integral

termination, selectable Baud rate of 1000, 500, 250, or 125 kBit/s.

The resolution is set at 0.02 mm and the output can be configured for

1 or 2 floats. The measurement direction is set to measure away from

the electronic housing and towards the tip of the pipe

Level Plus

LLE

Operation Manual