Amplitec C10G-CP Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Amplitec C10G-CP. Amplitec C10G-CP 13 pagina's. Wide band mini booster

1. DC+5V Power supply voltage is +5V

2. BS Output port, to be connected with service antenna

3. Grounding, equipment can be grounded by screwing

4. MS Input port, to be connected with donor antenna

5. CDMA Alarm Indicator

Green Means ALC doesn't work

Orange Means ALC starts control in 5~10dB

Red Means ALC starts control in 15~20dB。

6. PCS Alarm Indicator

Green Means ALC doesn't work

Orange Means ALC starts control in 5~10dB

Red Means ALC starts control in 15~20dB。

7. PCS ATT :

To adjust Uplink or Downlink Gain. ( arrow pointed to 5 means the gain will be

reduced 5dB; arrow pointed to 10 means the gain will be reduced 10db ; arrow

pointed to

15 means the gain will be reduced 15dB )

8. Celluar ATT:

To adjust Uplink or Downlink Gain. ( arrow pointed to 5 means the gain will be

reduced 5dB; arrow pointed to 10 means the gain will be reduced 10dB ; arrow

pointed to 15 means the gain will be reduced 15dB )

Installation Guide

Make sure have sufficient cable length between proposed donor to server antenna

location and booster connector.

Make sure the position you install the booster is near to one existing electrical outlet,

and well ventilated, away from excessive heat, moisture, direct sunlight.

Install your donor antenna on the roof where there is the strongest signal.

Mount your signal booster, connect cables to the signal booster from the outside

antenna and inside antenna at the designated ports, and connect the booster to AC

power supply.

Install the indoor antenna where you want to improve signals.

Amplify your world

7 / 13