FOLLO FUTURA STABILIS 104-206-11 Handmatig - Pagina 8
Blader online of download pdf Handmatig voor {categorie_naam} FOLLO FUTURA STABILIS 104-206-11. FOLLO FUTURA STABILIS 104-206-11 13 pagina's. Arm trainer
Pagina afdrukken
5. Use on wall bars or on table/floor: The machine is designed for use on wall
bars, on a table or on the floor. As shown in the drawing above the forward
attachments on the frame are plastic coated hooks which are used either to hang
the machine on wall bars or as a feet when using the machine on table or floor.
Maintenance
Inspect the machine regularly for damage, play or missing parts. In the case of
damage or other deficiencies, the machine must not be used until it has been
repaired.
Trouble shooting
Counter / computer:
If the counter stops working (empty display), check the battery first. If the
counter is working, but does not count, check that the black transmitter on the
largest nickel plated disc (No. 28 on the parts drawing) is in position. Check
also that the opening between the black transmitter and the sensor
(immediately below the computer) is correct when they pass each other. The
opening must be between 2 and 4 millimetres (maximum 5 millimetres). Adjust
the opening by carefully bending the baseplate to which the sensor is
attached. See also the folder that accompanied the computer.
Brake resistance:
If no brake resistance is felt or the resistance is not functioning properly, the
handle may have been adjusted too far in the wrong direction (several turns).
Turn the handle clockwise until heavy resistance is felt. Then adjust to the
required resistance. If resistance is uneven, inspect the brake lining (No. 29 on
the parts drawing). If the brake lining has loosened, it must be replaced.
If these guidelines fail to rectify the situation or if there are other faults or
deficiencies, contact your dealer for replacement parts or for service.
NB! The manufacturer responsibility for CE marking is invalidated if any form
of modification is carried out.
Extra equipment
-Comfort discs for handles
-Gloves for handles
-Pedals
-Floor plates
Technical specifications
Weight
8,3 kg
Height:
45 cm
Recycling
This machine is comprised mainly of steel and plastic. When separating for
recycling, the handles and plastic details must be handled as hazardous waste.
The remaining parts of the machine can be handled as metal.
The "CE" mark indicates that this product conforms with European
standards for health, safety and the environment.
Width:
59,5 cm
Length:
56 cm
08/08/18
Side 8
Rev: 12