Ampt ANALOGER ADG-1 Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Ampt ANALOGER ADG-1. Ampt ANALOGER ADG-1 20 pagina's. 100% analog bucket brigade delay
Pagina afdrukken
Set up
Use only standard, REGULATED, 9VDC, center-negative power supplies
rated for at least 200mA from a reputable vendor for all your Asheville
Music Tools effects. Classic old style, rectified & filtered, but unregulated,
supplies are not acceptable for use with this product. We like the
Truetone™ One Spot® and similar products.
The ADG-1 will draw up to 125mA when engaged so be careful when
using multi output supplies that are rated for only 100mA. Use the higher
current outputs when using this type of supply. Never use a higher
voltage supply with this product. There are no sonic benefits and you will
risk damaging the pedal and void the warranty. The pedal will not turn on
if it detects an overvoltage supply. The Analoger Series of pedals high
current draw make it impractical to use with a conventional 9V battery.
The ADG-1 has an input level control and flexible bypass making it able to
be used in various configurations for guitar, synthesizer or line level
applications, including:
Standard pedal use: ADG-1 connected into an amplifier input,
with or without other pedals. You may use the pedal in either
Buffered or True bypass mode in this configuration.
Insert Effect: Connect the ADG-1 to the effects send/return of
your power amp or mixing console. Or use the ADG-1 to replace
the existing preamp if connected to just the return. Use this in
buffered Bypass mode only.
DI (Direct Input): The ADG-1 can be used to impedance match
to a mixer or DAW input for the correct drive and impedance
conversion from the guitar's high impedance out to the low
impedance of a console or DAW line in. It can also be used as a
buffered drive pedal placed before other pedals. For best results
use with 10K or higher input impedance. Not suitable for
600ohm input impedance of some classic consoles. Use this in
buffered Bypass mode only.
<6>