Carco 30B Installatiehandleiding - Pagina 6
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Carco 30B. Carco 30B 11 pagina's. For ji case 650k/750k/850k
MOUNTING GROUP
17. Guide the winch into position on the winch mounting
brackets.
18. Fasten the winch to the brackets using the nuts (items
17 & 19) and washers (items 14 & 16). Torque the
nuts per note 5.
19. Attach the winch driveshaft to the winch input yoke
using the cap and bolt kit (item 8). Apply Loctite 243
or equivalent to the bolt threads.
20. Measure the vertical and horizontal position of the
winch driveshaft as it passes through the tractor rear
cover relative to the mounting holes for the small trac-
tor PTO access opening cover. NOTE: The driveshaft
typically will NOT be centered within the PTO access
opening and the location of the driveshaft can vary
between tractors.
21. Transfer the measured dimensions to the PTO
access cover and cut a hole that is ¼ in. (6 mm) larg-
er than the largest diameter of the driveshaft at the
point that it passes through the tractor rear face. If
required, grind clearance in the tractor rear face
cover.
22. Using a saw, cut the PTO access opening cover in
half vertically to allow for installation around the drive-
shaft. Install the PTO access cover to the tractor rear
face using the existing hardware.
23. Install the bottom guard (item 9) as shown, using fas-
teners (items 14 & 20).
24. Before operating the winch, be sure the winch is filled
to the proper level with the recommended oil.
CAUTION
To prevent serious damage to winch, do not run the
tractor engine without oil in the winch.
6