Carco 30B Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Трактор. Carco 30B. Carco 30B 11 сторінок. For ji case 650k/750k/850k

MOUNTING GROUP

17. Guide the winch into position on the winch mounting

brackets.

18. Fasten the winch to the brackets using the nuts (items

17 & 19) and washers (items 14 & 16). Torque the

nuts per note 5.

19. Attach the winch driveshaft to the winch input yoke

using the cap and bolt kit (item 8). Apply Loctite 243

or equivalent to the bolt threads.

20. Measure the vertical and horizontal position of the

winch driveshaft as it passes through the tractor rear

cover relative to the mounting holes for the small trac-

tor PTO access opening cover. NOTE: The driveshaft

typically will NOT be centered within the PTO access

opening and the location of the driveshaft can vary

between tractors.

21. Transfer the measured dimensions to the PTO

access cover and cut a hole that is ¼ in. (6 mm) larg-

er than the largest diameter of the driveshaft at the

point that it passes through the tractor rear face. If

required, grind clearance in the tractor rear face

cover.

22. Using a saw, cut the PTO access opening cover in

half vertically to allow for installation around the drive-

shaft. Install the PTO access cover to the tractor rear

face using the existing hardware.

23. Install the bottom guard (item 9) as shown, using fas-

teners (items 14 & 20).

24. Before operating the winch, be sure the winch is filled

to the proper level with the recommended oil.

CAUTION

To prevent serious damage to winch, do not run the

tractor engine without oil in the winch.