Bosch 800 Series Installatiehandleiding - Pagina 13

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Bosch 800 Series. Bosch 800 Series 48 pagina's. Built-in wall ovens
Ook voor Bosch 800 Series: Handleiding voor installatie-instructies (24 pagina's), Installatiehandleiding (40 pagina's), Gebruiks- en onderhoudshandleiding (12 pagina's), Installatiehandleiding (23 pagina's), Installatiehandleiding (28 pagina's), Installatiehandleiding (32 pagina's), Gebruiksaanwijzing (32 pagina's), Installatiehandleiding (32 pagina's), Snelstart- en veiligheidshandleiding (7 pagina's), Gebruiks- en onderhoudshandleiding (40 pagina's), Installatiehandleiding (40 pagina's), Installatiehandleiding (32 pagina's), Handleiding voor installatie-instructies (40 pagina's), Gebruiks- en onderhoudshandleiding (33 pagina's), Gebruiks- en onderhoudshandleiding (49 pagina's), Snelstarthandleiding (7 pagina's), Snelstart- en veiligheidshandleiding (13 pagina's), Installatiehandleiding (32 pagina's), Servicehandleiding (36 pagina's), Handleiding voor installatie-instructies (29 pagina's), Gebruiks- en onderhoudshandleiding (24 pagina's), Gebruiks- en onderhoudshandleiding (40 pagina's), Handleiding voor installatie-instructies (28 pagina's)

Pagina afdrukken

Screw the adjustable feet into the mounting holes on

the underside of the appliance.

Note: If the appliance needs to be moved again,

screw the adjustable feet in fully.

Carefully move the appliance back onto its feets.

Turn the adjustable feet to align the appliance.

Note: Measure the installation height of the cabinetry

and adjust appliance height accordingly prior to

placing appliance in cabinetry.

Connect Gas Supply

The appliance is shipped from the factory for use with

natural gas at a pressure of 5" water column. When

checking for proper operation of the regulator, the inlet

pressure must be at least 1" greater than the operating

(manifold) pressure above. When used with natural gas,

the pressure supplied to the regulator must be between

6" and 10,5" water column.

To convert the appliance to propane gas see

"Conversion to propane gas (LPG)". A qualified

technician or installer must do the conversion.

Use a flexible gas pipe with a length of at least 5 ft

(1.5 m).

The gas inlet to the unit is located at the right rear of the

appliance.

Install the pressure regulator (supplied with unit) to gas

inlet. Postion the gasket (supplied with unit) in between

the inlet and the regulator. Position the regulator to have

it cap D (~ Page 19) easily accessible. Turn the nut on

gas inlet to hand tighten plus 1/3 turn.

Install the gas pipe to the regulator using Teflon tape or

pipe-joint compound (resistant to propane gas and

natural gas). Turn to hand tighten plus 1/3 turn. Do not

exceed 1 turn for alignment, to prevent possible damage

to the gas pressure regulator.

Check inlet fittings and regulator for leaks.

* Attached to the appliance.

WARNING

Do not attempt any adjustment of the pressure

regulator, except when converting to propane.

Adjustments could lead to leaks or cause incorrect

gas pressure to the appliance.

Side and Back View Gas Cooker Installation

Gas Location

Gas connection

Electrical connection

Connect the gas supply line to the unit pressure

regulator using a 1/2" flex gas line connector between

manual shut-off valve and pressure regulator. A metal

flex line or fixed metal pipe shall be used to connect gas

to the appliance. If a metal gas line cannot be used,

consult your local certified electrician or local electric

codes for proper grounding.