DRAKE SDE24 Gebruiksaanwijzing - Pagina 9
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} DRAKE SDE24. DRAKE SDE24 18 pagina's. Hybrid qam modulator; digital tuner and demodulator module; encoder module; asi input module
Ook voor DRAKE SDE24: Gebruiksaanwijzing (19 pagina's)
Pagina afdrukken
Setup and Programmng / Software Flow Chart
Programming and viewing of the various setup and operating
parameters is accomplished using the front panel back lit,
two line, sixteen character wide LCD along with the two LEFT
and RIGHT 'ENCODER SELECT' buttons and the five LEFT,
RIGHT, UP, DOWN and ENTER buttons. The name of the
parameter is on the top line of the display and the setting
value is on the bottom line.
To observe a certain parameter setting without intending to
change its value, just use the LEFT and RIGHT ENCODER
SELECT buttons and the LEFT and RIGHT arrow buttons to
navigate through the menus shown in the software flow chart
below. The current setting for each parameter is shown on
the bottom line of the display. Note that depending upon
certain settings, some screens are not needed and will be
skipped.
EH24 ENCODER HOST & SDE24 ENCODER MODULE
ENCODER
SELECT
UNIT ID
SETUP:
EH24
Note: All installed encoders
have the same software flow
patterns as shown here
for encoder "xx".
SETUP:
VIDEO
ENCODER xx
(1 thru 12)
VIDEO
S-VIDEO
COMPOSITE
SOFTWARE FLOW CHART
NORMAL MODE
RS-232
ENCODER:
BAUDRATE
1 thru 12
1 thru 12
NORMAL MODE
FORMAT
BITRATE:
FORMAT
BITRATE:
MPEG2
MPEG4 H.264
(This screen only appears
for Encoder 1 in a given
SDE24 module. Encoder 2
in that module is always
forced to MPEG2.)
To make a change in the displayed parameter and its setting
and if this is the initial setup, you will want to enter the
'program' mode. To do this, press the ENTER button that is
located in the center of the four arrow buttons and hold in for
several seconds until the bottom line of the display begins to
flash.
After you are in the program mode (bottom line of screen
flashing) use the LEFT and RIGHT arrows to navigate among
screens and use the UP and DOWN arrows to change the
parameter setting. When ENTER is pressed, the new
settings will be loaded and stored and the unit will exit the
'program' mode. You may wish to not press ENTER until you
have gone through all screens and settings and then press
ENTER to save and load all changes in one step, OR you
can store just one or several parameters at a time and
reenter program mode to set the next. Either method is
acceptable.
ENTER
(This screen
appears only
if ITU-B
is selected.)
I128, J1
I128, J5
I128, J2
I8, J16
I64, J2
I128, J6
I128, J3
I4, J32
I132, J4
I128, J7
I128, J4
I2, J64
I16, J8
I128, J8
I1, J128
RESOLUTION
9
(This screen
appears only
if ITU-A is
selected.)
ITU-A
ITU-B
(This screen
appears only
if ITU-A is
selected.)