Draper 146012 Installatie- en bedieningsinstructies - Pagina 3
Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Draper 146012. Draper 146012 8 pagina's. Electric projection screen
Pagina afdrukken
Access FIT E and V
Section 2 - Hanging Screen
Please Note: When locating viewing surface and checking clearance for screen operation, ensure that surface is centered in the case.
1. Engage each case mounting bracket
2. Screen should be sufficiently supported to withstand
vibration.
Please Note: A hoisting bracket is included on each end of the
case to aid in overhead installation.
3. Ensure that fasteners are of adequate strength and suitable
for the mounting surface chosen. Supporting hardware
such as chains, cables, two 3/ 8 "
precisely vertical.
4. Entire bottom of case must be readily accessible after
installation is complete.
5. Front, back, and top of case must be straight—not forced
to warp or bow.
CAUTION: Screen case and flange are not designed to
serve as ceiling support.
6. Do not seal unit in ceiling until electrical connections have
been made and screen operates successfully.
Please Note: If case is painted on location, removal of roller/
fabric assembly is recommended prior to painting. If not
removed, slot on bottom of case should be shielded to
protect viewing surface from paint splatters/overspray.
Section 3 - Bottom Access FIT Panel Installation/Removal
Bottom Access Panel Door
CAUTION: Beware of pinch points at ends of closure
CAUTION: For larger sizes, the following requires two people to perform safely.
1. Press up on Access FIT panel and pull toward the front of the
screen housing to disengage hinges and remove Access FIT panel.
Access
Panel Door:
Remove Screws
Pivot on Hinges.
from both ends
of Screen Housing.
with top of housing
(attached to case)
rods, etc., must be
(9.5 mm)
TYPICAL
INSTALLATION
With typical installation, brackets
may be angled to meet installation requirements.
Bottom flange of
Access housing
Figure 4
Removing Access Panel
and tighten set screws.
(Fig. 2)
HOISTING
BRACKET
HOISTING
BRACKET
CASE
MOUNTING
BRACKET
TYPICAL
INSTALLATION
With typical installation, brackets
may be angled to meet installation requirements.
Bottom Access FIT panel secures to the screen housing
with two screws
(one on each end)
position by engagement brackets with ball detents that
snap into case support brackets
Figure 3
Access case as seen from below
2. To Remove/Install Support Brackets:
CASE
MOUNTING
BRACKET
⁄
"
(22mm)
ELECTRICAL
KNOCKOUT
⁄
"
(22mm)
ELECTRICAL
KNOCKOUT
ALTERNATE
INSTALLATION
Additional set of brackets
required, but NOT included.
ALTERNATE
Figure 2
INSTALLATION
Installation of Case
Additional set of brackets
required, but NOT included.
, and held in the closed
.
(Fig. 3)
page 3 of 8
CASE
MOUNTING
BRACKETS
Access Panel
Support Bracket
Attaching Brackets:
Insert pin in top
1
slot and push up.
Rotate bracket
2
clockwise to lock
bracket in place.
Engagement Bracket
With Ball Detent:
will snap into Access
Panel Support Bracket.