Draper 146012 Installatie- en bedieningsinstructies - Pagina 4
Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Draper 146012. Draper 146012 8 pagina's. Electric projection screen
Pagina afdrukken
Access FIT E and V
Figure 5
Idler End
Mounting
Bracket
Figure 6
Idler End
Retaining
Clip
Section 4 - Motorized Roller/Fabric Installation
Please note: When ordering motor with internal Low-Voltage Controller, if case ships separately from contents, case includes 25'
and special low-voltage switch.
1. Remove bottom Access FIT panel
2. Back out set screws from top side of motor mounting brackets
3. To engage motor end bracket flange
motor bracket to rest flat against top inside housing.
4. Rotate bracket clockwise until it engages in channel.
5. Engage idler end bracket in same manner as motor end bracket and slide toward opposite end of screen housing.
CAUTION: Step 6 requires two people to perform safely.
6. Locate black washer and retaining clips attached to instruction sheet. Lift roller/fabric assembly into screen housing and engage motor head completely into motor
bracket, making sure limit switch adjusting knobs are visible from bottom of screen housing.
Please Note: If snap ring is provided, make sure it engages with motor. If retaining clip is provided instead, install to lock motor end in place.
7. Support idler end of roller and slide mounting bracket toward roller. Insert roller pin into nylon bushing on idler bracket.
8. Roller idler pin goes through idler bracket. Reinstall washer and retaining clip.
CAUTION: Failure to replace washer and retaining clip could result in separation of roller from brackets.
9. Center roller/fabric assembly by sliding mounting brackets left or right.
10. Securely tighten set screws on roller mounting brackets.
11. Connect electrical plug from motor to mating socket on junction box.
12. Attach door support brackets.
13. Reinstall bottom access panel as previously described.
Section 5 - Motorized Roller/Fabric Removal
Reverse the previous instructions
("Motorized Roller/Fabric Installation")
IDLER END OF CASE
BOTTOM VIEW
SIDE VIEW
.
(See Section 3)
(See Fig 5)
(above the two channels in the top of the screen housing)
for removal of unit.
MOTOR END OF CASE
SIDE VIEW
Motor End
Mounting
Bracket
Figure 7
.
, rotate bracket approximately 45° counterclockwise to allow top surface of
page 4 of 8
BOTTOM VIEW
Set Screws
Motor End
Retaining Clip
cable
(7.6m)