Bosch WAE24167GB Gebruiksaanwijzing en installatie-instructies - Pagina 23
Blader online of download pdf Gebruiksaanwijzing en installatie-instructies voor {categorie_naam} Bosch WAE24167GB. Bosch WAE24167GB 32 pagina's.
Pagina afdrukken
Faults and what to do about them.
Faults
Water is running out.
Water not flowing in.
Detergent is not being dis-
pensed.
The door cannot be
opened.
Programme does not
start.
The water is not draining.
Water is not visible in the
drum.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
Residual water in the care
product dispenser.
There are odours or
greasy deposits in the
washing machine.
The indicator light for N
Wash is flashing. Foam
may also be leaking from
the detergent drawer.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
Cause/remedy
Attach the drain hose correctly or replace it. ~ Page 29
■
Tighten the threaded joint on the inlet hose. ~ Page 28
■
Has the Start button been pressed?
■
Is the tap turned on? ~ Page 28
■
Could the filter be clogged? Clean the filter. ~ Page 21
■
Is the inlet hose kinked or trapped?
■
The safety function is activated. Stop programme? ~ Page 16
■
$ Rinse Stop (without final spin) selected?
■
Can the door only be opened by the emergency release? ~ Page 21
■
Has the Start button been pressed to pause the programme?
■
Is the door closed?
■
$ Rinse Stop (without final spin) selected?
■
Clean the drain pump. ~ Page 20
■
Clean the drain pipe and/or the drain hose.~ Page 21
■
Not a fault – the water is below the visible area.
■
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
Has the additional programme setting p Easy-Iron also been selected?
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault; the foam detection system is active – a rinse cycle has been
■
switched on.
Not a fault – the effectiveness of the care product is not affected.
■
If necessary, clean the insert and detergent drawer. ~ Page 19
■
Run the Cottons 90 °C programme without any laundry. Use standard
■
detergent for this.
Have you used too much detergent? Mix one tablespoon of fabric softener
■
with 1/2 litre of water and pour into compartment II (not for outdoor fabrics
or those made with down). Use less detergent in the next washing cycle.
Appliance aligned? Align the appliance. ~ Page 30
■
Are the appliance's feet secured? Secure the appliance's feet. ~ Page 30
■
Have the transport braces been removed? Remove the transport braces.
■
~ Page 26
Faults and what to do about them.
en
23