Bosch WAE24167GB Instrukcja obsługi i instrukcja instalacji - Strona 23
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Bosch WAE24167GB. Bosch WAE24167GB 32 stron.
Drukuj stronę
Faults and what to do about them.
Faults
Water is running out.
Water not flowing in.
Detergent is not being dis-
pensed.
The door cannot be
opened.
Programme does not
start.
The water is not draining.
Water is not visible in the
drum.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
Residual water in the care
product dispenser.
There are odours or
greasy deposits in the
washing machine.
The indicator light for N
Wash is flashing. Foam
may also be leaking from
the detergent drawer.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
Cause/remedy
Attach the drain hose correctly or replace it. ~ Page 29
■
Tighten the threaded joint on the inlet hose. ~ Page 28
■
Has the Start button been pressed?
■
Is the tap turned on? ~ Page 28
■
Could the filter be clogged? Clean the filter. ~ Page 21
■
Is the inlet hose kinked or trapped?
■
The safety function is activated. Stop programme? ~ Page 16
■
$ Rinse Stop (without final spin) selected?
■
Can the door only be opened by the emergency release? ~ Page 21
■
Has the Start button been pressed to pause the programme?
■
Is the door closed?
■
$ Rinse Stop (without final spin) selected?
■
Clean the drain pump. ~ Page 20
■
Clean the drain pipe and/or the drain hose.~ Page 21
■
Not a fault – the water is below the visible area.
■
Not a fault – the unbalanced load detection system has interrupted the spin
■
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
Has the additional programme setting p Easy-Iron also been selected?
■
Is the selected speed too low?
■
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
■
ance by repeatedly distributing the laundry.
Not a fault; the foam detection system is active – a rinse cycle has been
■
switched on.
Not a fault – the effectiveness of the care product is not affected.
■
If necessary, clean the insert and detergent drawer. ~ Page 19
■
Run the Cottons 90 °C programme without any laundry. Use standard
■
detergent for this.
Have you used too much detergent? Mix one tablespoon of fabric softener
■
with 1/2 litre of water and pour into compartment II (not for outdoor fabrics
or those made with down). Use less detergent in the next washing cycle.
Appliance aligned? Align the appliance. ~ Page 30
■
Are the appliance's feet secured? Secure the appliance's feet. ~ Page 30
■
Have the transport braces been removed? Remove the transport braces.
■
~ Page 26
Faults and what to do about them.
en
23