Electrolux EW 1055 F Instructieboekje - Pagina 10

Blader online of download pdf Instructieboekje voor {categorie_naam} Electrolux EW 1055 F. Electrolux EW 1055 F 24 pagina's. Electrolux washing machines

Pagina afdrukken

Important!

The first time you use the washing machine,

when you switch it on, it may display a blinking zero and

give an audible warning signal. This is due to the fact

that the washing machine has performed a washing

cycle during the manufacturer's inspection tests, and

this cycle has not been erased after its completion.

• Delay start, a time value indicated in hours and

selected by means of the relevant button.

The delay time is displayed for 3 seconds, then the

duration of the selected programme reappears.

After you have pressed the START/PAUSE button,

the countdown begins, and the delay time value

decreases by one unit every hour.

You can delay the start of the selected programme

by up to 24 hours in one hour intervals.

• An incorrect option selection has been made:

this is indicated by the message Err when a

function incompatible with the current programme

is selected.

The incorrect selection is also indicated by an

audible warning signal.

• An alarm code indicates a fault in the machine

operation (see the relevant chapter on page 21).

9 START/PAUSE button

This button has three functions:

• Start: after you have selected the desired

programme and options, press this button to start

the washing machine. The light above the button

will stop flashing and remain lit.

If you have selected a delay time by means of

button 11, the countdown will begin and will be

shown on the display.

• Pause: when you press this button again, the

programme in progress is interrupted. The light

above the button will start flashing. To restart the

programme, press the button again.

When you PAUSE the cycle, the DOOR LOCKED

light goes out, and it becomes possible to open the

door, provided

• the washing machine is not in the heating phase;

• the level of the water is not high;

• the drum is not turning.

Important! You must set the washing machine to

PAUSE before you make any change in the

programme in progress.

• Draining of water and spinning after the

execution of programmes with the RINSE HOLD

option.

10 SKIP/RESET button

At the end of a programme, you must press this

button once or repeatedly, in order to clear the

contents of the memory (the display will show three

blinking dashes); otherwise, the next time you switch

the washing machine on, the blinking zero will

reappear and the audible warning signals relevant to

the end of the previous cycle will be given.

You can also press the RESET button to exclude

one or several phases of the programme which is

running, as indicated below.

- set the washing machine to PAUSE by pressing the

START/PAUSE button (the relevant light will flash);

- press the RESET button once or several

times, until the required phase(s) is(are) cancelled

(the light next to the name of the phase(s) will go out).