DrBrowns 850T Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} DrBrowns 850T. DrBrowns 850T 5 pagina's. Deluxe bottle warmer
Ook voor DrBrowns 850T: Handmatig (8 pagina's)

DrBrowns 850T Handmatig
TO OPERATE THE APPLIANCE:
1. Bottle: Remove all bottle components,
fill the bottle with milk, apply storage
cap (included) and secure, position
bottle in the basket and then place
it into the heating chamber.
Food Jar: Loosen lid and position jar in the
basket and then put it into the heating chamber.
NOTE: The basket has 2 parts. The bottom section can be turned upside
down so that smaller bottles sit higher up in the heating chamber and are
easier to remove. (SEE FIGURE 4)
CAUTION: To prevent the bottle from leaking, always remove all bottle
components and use the included storage cap during warming.
NOTE: To empty the heating chamber, unplug the product and remove the
reservoir from the side. With the cover open, tip the unit over a sink with the
reservoir opening facing up and drain any remaining fluid from inside the
heating chamber through the top opening.
2. Close the cover. Never use this appliance without the basket insert in place
and properly adjusted for the bottle or jar size.
CAUTION: DO NOT open the lid of the heating chamber once the heating cycle
has been started. DO NOT reach over the top of the unit while it is in operation
as this could cause injury.
3. Press any button on the keypad (except O) to display the
"last time used". If correct, press >. If you want to adjust
the time, press the up arrow button to increase the length
of time or the down arrow button to decrease the time.
NOTE: Pressing and holding an arrow button will cause
the timer display to change very fast. To change the
timer slowly, push and release the arrow button so the numbers move
incrementally. Once the display shows the desired time, press start button.
(SEE FIGURE 5)
4. When the heating cycle is complete the display will flash 00:00 for 60 seconds
and then shut off. At that time, there will be 5 audible beeps that indicate
the cycle time you selected is complete and the bottle or food is ready to be
removed from the appliance. You can open the top of the product at this point.
NOTE: You can turn the appliance off any time by pressing the O button.
CAUTION: Be careful of the steam rising out from the heating chamber.
DO NOT put your hands on or around the heating chamber during or
immediately after the heating cycle.
8
FIGURE 4
FIGURE 5
5. Grasp the side tabs of the basket and remove it immediately
to prevent residual heating. Place it on the countertop and
remove the bottle or jar. (SEE FIGURE 6)
6. Gently swish the fluid in the bottle around or stir the food
thoroughly so the temperature becomes uniform throughout
the container.
7. ALWAYS TEST THE TEMPERATURE OF THE FLUID OR FOOD
BEFORE FEEDING YOUR BABY.
NOTE: The appliance is programmed to automatically reduce the time for an
additional heating cycle started within 15 minutes of the end of the previous
cycle. If you heat a second bottle immediately, you will see that time is reduced
by a pro-rated amount unless you override the feature and set a new time
yourself.
NOTE: The appliance is equipped with an internal sensor that will automatically
shut the unit off if it gets too hot or runs out of water. The switch will
automatically reset once the unit cools down.
NOTE: For microbiological and hygienic reasons, once milk or food is heated,
it should not be re-heated again and should be discarded if not used
immediately. Please consult your health professional for further guidance
about safety recommendations on feeding.
TO CLEAN THE APPLIANCE:
• Always unplug the appliance and ensure it is cool before cleaning any part.
• Remove water reservoir and empty all water out of the unit.
• Rinse reservoir with mild soapy water and rinse with clean water.
• Wipe the exterior surfaces as well as the inside of the heating chamber with a
damp cloth or sponge using mild soap. DO NOT submerge the unit in any water
or liquid.
• Removable baskets are dishwasher safe (top rack) or wash with soapy water.
Rinse with clean water. Air dry.
• DO NOT use scouring pads, abrasives, bleach or solvents for cleaning.
• DO NOT disassemble the product. There are no serviceable parts inside.
FIGURE 6
WSW004_F2
9