Bosch 2 Gebruiksaanwijzing en installatie-instructies - Pagina 24

Blader online of download pdf Gebruiksaanwijzing en installatie-instructies voor {categorie_naam} Bosch 2. Bosch 2 36 pagina's. Mini blender
Ook voor Bosch 2: Snelle installatiehandleiding (16 pagina's), Handleiding voor installatie en gebruik (18 pagina's), Originele handleiding (13 pagina's), Originele handleiding (22 pagina's), Gebruiksaanwijzing (32 pagina's), Gebruikershandleiding (28 pagina's), Gebruikershandleiding en installatie-instructies (16 pagina's), Gebruiksaanwijzing (42 pagina's), Gebruiksaanwijzing (8 pagina's), Gebruiksaanwijzing (8 pagina's), Gebruiksaanwijzing (12 pagina's), Snelstarthandleiding (2 pagina's), Snelstarthandleiding (9 pagina's), Gebruikershandleiding en installatie-instructies (48 pagina's), Gebruiksaanwijzing (26 pagina's), Snelle referentiehandleiding (2 pagina's), Gebruikershandleiding en installatie-instructies (24 pagina's), Gebruiksaanwijzing (42 pagina's), Informatie voor gebruik (28 pagina's), Gebruikershandleiding (40 pagina's), Gebruikershandleiding en installatie-instructies (35 pagina's), Gebruikershandleiding (24 pagina's)

Bosch 2 Gebruiksaanwijzing en installatie-instructies

Faults and what to do about them.

en
Faults and what to do about them.
Faults
Water is running out.
Water not flowing in.
Detergent is not being dis-
pensed.
The door cannot be
opened.
Programme does not
start.
The water is not draining.
Water is not visible in the
drum.
The spin result is not sat-
isfactory.
Laundry wet/too damp.
The spin cycle runs sev-
eral times.
The programme is taking
longer than usual.
The length of the pro-
gramme changes during
the wash cycle.
Residual water in the care
product dispenser.
There are odours or
greasy deposits in the
washing machine.
N Wash/Active indica-
tor light flashes. Foam
may also be leaking from
the detergent drawer.
24
Cause/remedy
Attach the drain hose correctly or replace it. ~ Page 30
Tighten the threaded joint on the inlet hose. ~ Page 29
Has the Start button been pressed?
Is the tap turned on? ~ Page 29
Could the filter be clogged? Clean the filter. ~ Page 22
Is the inlet hose kinked or trapped?
The safety function is activated. Stop programme? ~ Page 18
- - - - Rinse Stop (without final spin) selected?
Can the door only be opened by the emergency release? ~ Page 23
Has the Start button been pressed to pause the programme, or has the
Ready in time been selected?
Is the door closed?
Is @ (childproof lock) activated? Deactivate. ~ Page 18
- - - - Rinse Stop (without final spin) selected?
Clean the drain pump. ~ Page 21
Clean the drain pipe and/or the drain hose.~ Page 22
Not a fault – the water is below the visible area.
Not a fault – the unbalanced load detection system has interrupted the spin
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum.
Programme for p Easy-Iron selected?
Is the selected speed too low?
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance.
Not a fault – the unbalanced load detection system is adjusting an imbal-
ance by repeatedly distributing the laundry.
Not a fault; the foam detection system is active – a rinse cycle has been
switched on.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the dis-
play panel.
Not a fault – the effectiveness of the care product is not affected.
If necessary, clean the insert and detergent drawer. ~ Page 20
Run the Cottons 90 °C programme without any laundry. Use standard
detergent for this.
Have you used too much detergent? Mix one tablespoon of fabric softener
with 1/2 litre of water and pour into compartment II (not for outdoor fabrics
or those made with down). Use less detergent in the next washing cycle.