Bosch 2 Kullanım Kılavuzu ve Kurulum Talimatları - Sayfa 24

Sayfayı Yazdır

Bosch 2 Kullanım Kılavuzu ve Kurulum Talimatları

Faults and what to do about them.

Faults

Water is running out.

Water not flowing in.

Detergent is not being dis-

pensed.

The door cannot be

opened.

Programme does not

start.

The water is not draining.

Water is not visible in the

drum.

The spin result is not sat-

isfactory.

Laundry wet/too damp.

The spin cycle runs sev-

eral times.

The programme is taking

longer than usual.

The length of the pro-

gramme changes during

the wash cycle.

Residual water in the care

product dispenser.

There are odours or

greasy deposits in the

washing machine.

N Wash/Active indica-

tor light flashes. Foam

may also be leaking from

the detergent drawer.

Cause/remedy

Attach the drain hose correctly or replace it. ~ Page 30

■

Tighten the threaded joint on the inlet hose. ~ Page 29

■

Has the Start button been pressed?

■

Is the tap turned on? ~ Page 29

■

Could the filter be clogged? Clean the filter. ~ Page 22

■

Is the inlet hose kinked or trapped?

■

The safety function is activated. Stop programme? ~ Page 18

■

- - - - Rinse Stop (without final spin) selected?

■

Can the door only be opened by the emergency release? ~ Page 23

■

Has the Start button been pressed to pause the programme, or has the

■

Ready in time been selected?

Is the door closed?

■

Is @ (childproof lock) activated? Deactivate. ~ Page 18

■

- - - - Rinse Stop (without final spin) selected?

■

Clean the drain pump. ~ Page 21

■

Clean the drain pipe and/or the drain hose.~ Page 22

■

Not a fault – the water is below the visible area.

■

Not a fault – the unbalanced load detection system has interrupted the spin

■

because the laundry is unevenly distributed.

Distribute small and large items of washing in the drum.

Programme for p Easy-Iron selected?

■

Is the selected speed too low?

■

Not a fault – the unbalanced load detection system is adjusting an imbal-

■

ance.

Not a fault – the unbalanced load detection system is adjusting an imbal-

■

ance by repeatedly distributing the laundry.

Not a fault; the foam detection system is active – a rinse cycle has been

■

switched on.

Not a fault – the programme sequence is optimised for the specific washing

■

process. This may change the length of the programme shown in the dis-

play panel.

Not a fault – the effectiveness of the care product is not affected.

■

If necessary, clean the insert and detergent drawer. ~ Page 20

■

Run the Cottons 90 °C programme without any laundry. Use standard

■

detergent for this.

Have you used too much detergent? Mix one tablespoon of fabric softener

■

with 1/2 litre of water and pour into compartment II (not for outdoor fabrics

or those made with down). Use less detergent in the next washing cycle.