Anchor WR-6400 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Anchor WR-6400. Anchor WR-6400 4 pagina's. 64 channel uhf wireless system

Pagina afdrukken

DIVERSITY WIRELESS BY ANCHOR AUDIO

Anchor Audio UHF wireless is a 64 channel, diversity wireless system that receives signals with two independent antennae.

With diversity wireless the receiver processes the stronger signal, effectively minimizing dropouts and interference from other

transmitting sources. The antennae are mounted internally so there are no obstructions or risk of damage.

CHANNEL SELECTION - BASE STATION RECEIVER

Before you can use your UHF wireless system, you will need to select a wireless frequency, set the receiver, and microphone

transmitter, to that channel.

1. Choose from any of the 64 available wireless channels

2. Set the receiver "GROUP" & "CHANNEL" selector knobs to the channel/frequency you have chosen

If you are using more than one wireless receiver repeat above for the each receiver. Remember each receiver/transmitter pair

must be set to different channels for proper operation.

NOTE: Ongoing wireless interference? The frequency you selected may be in use by

other systems in the area! Change channels until you find a clear frequency!

FCC STATEMENT

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference and

(2) This device must accept any interference received, including interference that may cause undesired operation.

NOTICE: The changes or modifications not expressly approved by the party responsible for compliance could void

the user's authority to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the

device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure

requirements and void user's authority to operate the device.

SAFETY

• Do not spill liquid on the unit and do not drop it on a hard concrete floor.

• Do not place the unit near heat sources such as radiators, amplifier, or etc.

• Do not expose to direct sunlight, extreme dust, excessive moisture, or vibration.

• Remove batteries from transmitter if the unit will not be used for a long period

to avoid the damage resulting from a leaking or otherwise defective battery.

ENVIRONMENT

• Do not throw used batteries into a fire or garbage bin with domestic rubbish. Be sure to dispose of used

batteries in accordance with local waste disposal rules.

• When disposing of the equipment, remove the batteries, separate the case, circuit boards and cables, and

dispose of all components in accordance with local waste disposal rules.

CONNECTING ANTENNAS & POWER SUPPLY

Connect both antennas to the receiver back panel for proper operation.

1. Screw antennas onto TNC connectors on receiver back panel

2. Position antennas pointing upward and slightly to the sides

ANTENNA B

Connecting the AC adapter to the receiver back panel.

1. Insert AC adapter into the DC IN connector

on receiver back panel

2. Plug AC adapter into electrical outlet

3. Push receiver Power knob on front panel

CONNECT RECEIVER TO AUDIO MIXER OR AMPLIFIER

Connect the receiver output to the audio mixer or amplifier input, using a standard audio cable with 3-pin XLR connectors

or "M" (6.3mm) phone plugs.

To assure sound quality and avoid distortion, please adjust receiver volume level according to the following instructions.

When using a standard audio cable with 3-pin XLR connectors or "M" (6.3mm) phone plugs to connect into:

MIC IN on audio mixer or amplifier, turn the Volume control

to the 1 o'clock position, the output level for balanced and

unbalanced output is about 77mV.

LINE IN on the audio mixer, turn the Volume control to the

MAX position, the output level for balanced and unbalanced

output is about 770mV.

ANTENNA A

DC IN JACK

ANTENNA INPUT CONNECTORS