Anchor-Caddie TMB101 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Anchor-Caddie TMB101. Anchor-Caddie TMB101 6 pagina's. Trolling motor bracket adapter kit

Pagina afdrukken

Trolling Motor Bracket Adapter Kit (TMB101)

Step 3 of 8

Dry Fit all pieces of the adapter kit, including your chosen quick release bracket.

This step is probably the most important step of all the processes. Although it's not difficult, you want to make sure you

take the time to get the best alignment possible to have your anchor nest as centered on your bow as you can.

Our adapter kit has so much adjustment possibilities that you have several different positions and adjustments that can

be made to get it as centered as possible, if not perfectly centered.

If you already have a quick release bracket installed, you will not dry fit with the whole quick release bracket, you will

just dry fit the adapter kit over that installation using your new quick release bracket Top Plate.

Looking at the pictures below, you can see the different options to get your proper angle and overhang.

Now that you have the location to mount the quick release bracket, it's time to mount the base plate of your

quick release bracket.

If you already have your quick release bracket installed from a previous installation, skip to step 5.

™ 2021 Anchor-Caddie

If this is a new installation,

you need to get your quick

release bracket base

mounted on the bow of

your boat. In this example,

we start by setting it close

to the corner of the bow.

As you can see, sliding

the Base Bracket

forward, we can get

good center alignment

but with more overhang

of the Base Bracket.

As you can see, by pulling

the quick release bracket

back, I can also get good

center alignment with a

more compact installation

reducing overhang of the

Base Bracket.

Now, set the adapter kit

on the quick release

bracket to see where your

center will end up. Now

let's slide the adapter kit

forward to see if we can

get it aligned.

But since this is a new

install, I'm going to Flip the

adapter kit 180 degrees

and pull the quick release

bracket back a bit.

Set your anchor nest on to

the adapter kit as a last

verification to make sure

it is centered and that

when you have your

anchor stowed, it doesn't

touch your bow.

Page 3 of 6