Dreame H12 Gebruikershandleiding - Pagina 7

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dreame H12. Dreame H12 14 pagina's. Wet and dry vacuum

Pagina afdrukken

How to Use

Switching Modes

The appliance is powered on in Auto mode by default, you can switch to Suction

mode as needed.

Auto Mode

While washing the floor, the appliance can adjust its suction

power according to different situations.

Suction Mode

If Suction mode is selected, the appliance will vacuum water only and the

brush roller will not be dampened. No water is coming out of the Clean

Water Tank.

Standard Mode (Handvac)

When the appliance converts to a handheld vacuum, it is powered on by

default in Standard mode.

Turbo Mode (Handvac)

Press the handvac mode switch to select the Turbo mode.

Using as a Floor Washer

1. Fill the Clean Water Tank: Press the Clean Water Tank release button to remove the

tank. Open the tank cover and fill the tank with clean water. Re-install the Clean Water

Tank and ensure it clicks into place.

Note:

•

For better cleaning performance, it is recommended to add 10ml detergent with the bottle cap into the full

Clean Water Tank, then shake gently and evenly for use.

•

Do not add any liquids other than the officially-approved cleaner.

How to Use

2. Start cleaning: Gently step on the brush cover and recline the appliance backwards.

Press the power switch

to start operating, press the mode switch

between the Auto mode and the Suction mode according to your needs.

＜140°

Note:

•

Do not vacuum any foamy liquids.

•

If the appliance is in the upright position while working, the current task will be suspended.

•

The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.

•

Do not recline the appliance backwards more than 140° to prevent the appliance from leaking water.

•

When the appliance is in operation, do not lift it off the ground, move it, tilt it or lay it flat. Doing so may cause the

used water to flow into the motor.

3. Empty the Used Water Tank: Press the Used Water Tank release button to take out the

tank. Remove the tank cover and pour out the used water. Close the tank cover and re-

install the tank before use.

to switch