ANDELI MCT-520DPL Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ANDELI MCT-520DPL. ANDELI MCT-520DPL 20 pagina's. Multifuction welding&cutting machine
Ook voor ANDELI MCT-520DPL: Gebruikershandleiding (8 pagina's)

Pagina afdrukken

5. INSTALLATION INSTRUCTION

The machine is equipped with power voltage compensation device. When the power voltage

fluctuates between±15% of rated voltage, it still can work normally.

When the machine is used with long cables, in order to prevent voltage form going down, bigger

section cable is suggested. If the cable is too long, it may have great affluence on the arc-striking

or other performance of cutting system, e.g. the HF arc-striking performance get weak or the

system work abnormally. So cables of configured length are suggested.

5.1 Make sure intake of the machine is not blocked or covered to avoid malfunction of cooling

system.

5.2 Connect the protective gas source. The gas supply passage shall include a gas cylinder, an

argon gas pressure reducing flowmeter and a gas pipe. The connecting portion of the gas pipe

shall be fastened with a hose clamp or other articles to prevent argon gas leakage and air ingress.

5.3 Ground the cables with section area no less than 6mm

to the housing, the way is connecting

screw in the back of the power source to ground device, or make sure ground terminal of power

socket is firmly connected. Both ways can be used for absolute safety.

5.4 According to the input voltage level of the welding machine, connect the power line to the

distribution box of the corresponding voltage level. Do not connect the wrong voltage. Also

ensure that the error of the power supply voltage is within the allowable range.