ANDELI MCT-520DPL 소유자 매뉴얼 - 페이지 8

{카테고리_이름} ANDELI MCT-520DPL에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ANDELI MCT-520DPL 20 페이지. Multifuction welding&cutting machine
ANDELI MCT-520DPL에 대해서도 마찬가지입니다: 소유자 매뉴얼 (8 페이지)

페이지 인쇄

5. INSTALLATION INSTRUCTION

The machine is equipped with power voltage compensation device. When the power voltage

fluctuates between±15% of rated voltage, it still can work normally.

When the machine is used with long cables, in order to prevent voltage form going down, bigger

section cable is suggested. If the cable is too long, it may have great affluence on the arc-striking

or other performance of cutting system, e.g. the HF arc-striking performance get weak or the

system work abnormally. So cables of configured length are suggested.

5.1 Make sure intake of the machine is not blocked or covered to avoid malfunction of cooling

system.

5.2 Connect the protective gas source. The gas supply passage shall include a gas cylinder, an

argon gas pressure reducing flowmeter and a gas pipe. The connecting portion of the gas pipe

shall be fastened with a hose clamp or other articles to prevent argon gas leakage and air ingress.

5.3 Ground the cables with section area no less than 6mm

to the housing, the way is connecting

screw in the back of the power source to ground device, or make sure ground terminal of power

socket is firmly connected. Both ways can be used for absolute safety.

5.4 According to the input voltage level of the welding machine, connect the power line to the

distribution box of the corresponding voltage level. Do not connect the wrong voltage. Also

ensure that the error of the power supply voltage is within the allowable range.