Anderson FF050 Bedieningshandleiding - Pagina 4

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Anderson FF050. Anderson FF050 8 pagina's.

However, it is not necessary to purge when the temperature is higher than 750°C. Air pipe or

gas pipe connected with burner should be tight enough with no leakage, also the periodically

check air or fuel nozzles of the burners to prevent to be blocked by dust, slag or other materials.

ATTENTION：DANGER OF BEEN BURNT

When burner in operation, combustion is severe, so the burner must be fixed. Hoses or cables

in area of the combustion system must be suitable for high temperature, to prevent high

temperature failure or cause safety accidents. Burners should be periodically inspected and

cleaned. Copper wire brush may be used, if necessary, to clean burner head. The burner system

should be checked twice a year for safety operation.

4. Configuration

FFO50 FlexFire® Oxygen Fuel Burner configuration as Fig 1 shown.it is made up by gas and

oxygen inlet, adjustment device and fix device.

Figure 1：FFO50 FlexFire® Oxygen Fuel burner Standard configuration

1. Fix burner bracket with bolts, gasket and washers to make sure the horizontal plate is level,

burner and burner block shown as Fig 2 shown.

2. Fix burner to burner bracket with clamp attached tightly.

3. Connect hose of the down comer to burner with quick connectors.

Anderson Thermal Soluions（Suzhou）Co., Ltd

Anderson Thermal Solutions – FFO50 Operation Manual