Electrolux 36" Ceramic Gebruiks- en onderhoudshandleiding - Pagina 15

Blader online of download pdf Gebruiks- en onderhoudshandleiding voor {categorie_naam} Electrolux 36" Ceramic. Electrolux 36" Ceramic 26 pagina's. 30” and 36” free-standing range hood
Ook voor Electrolux 36" Ceramic: Handleiding voor installatie-instructies (7 pagina's), Installatie-, gebruiks- en onderhoudshandleiding (22 pagina's), Handleiding voor installatie-instructies (25 pagina's), Handleiding voor installatie-instructies (8 pagina's)

Pagina afdrukken

OPERATING THE TRIPLE SURFACE RADIANT ELEMENT

Both the 30" and 36" cooktops are equipped with "Triple" surface radiant

elements located as shown in Figs. 1 & 2. A touch key pad on the element

controls is used to select one of the 3 positions of the element. Indicator

lights on the control panel are used to indicate which coil of the triple radiant

element will heat. One indicator light on indicates that only the INNER coil

will heat (Fig. 3). Two indicator lights on indicate that both INNER and

MIDDLE coils will heat (Fig. 4). Three indicator lights on indicate that all 3

portions of the element will heat (Fig. 5). You may switch from either of

these settings at any time during cooking.

To Operate the Triple Surface Element:

1. Place correctly sized cookware on the radiant surface element.

2. Touch and hold the

POWER

indicator light above the

pad is touched within 20 seconds the request to Power ON the

cooktop will clear.

3. Touch and hold the pad for the desired triple element position

until a beep is heard. The indicator light located above the

pad will glow. Note: If no further pads are touched within 10 seconds the request to

power the element ON will clear.

4. Select the INNER (Fig. 3), MIDDLE (Fig. 4) or ALL 3 element (Fig. 5) to heat by

touching the

key pad.

size

5. Touch

pad once to turn ON the power level to HI. Touch

MEDIUM, touch

pad once for power level to LO or touch

power level to KEEP WARM setting.

6. Each touch of the

lowest power level available. Note: The power level may be adjusted at any time while

the element is ON.

7. Start most cooking operations on a higher setting and then turn to a lower setting to

finish cooking. Each surface element provides a constant amount of heat at each

setting. A glowing red surface heating area extending beyond the bottom edge of the

cookware indicates the cookware is too small for the surface heating area.

8. When cooking has been completed touch the

and if no other surface element is used touch the

Note: The Hot Surface Indicator Light will turn ON if the cooktop is still hot and will

remain ON until the heating surface area has cooled sufficiently.

NOTE

See the Recommended Setting for Surface Elements table, on page 12, to make the correct setting.

Setting Surface Controls

key pad until a beep sound. The power

will turn ON. Note: If no other key

POWER

pad will increase or decrease the power level. Lo is the

ON OFF

lock

warm

POWER

ON OFF

pad once for

med

pad once to set the

warm

pad once to turn the element OFF

key pad to turn off the cooktop.

POWER

med

POWER

lock

warm

ON OFF

size

ON OFF

size

ON OFF

hot surface

Fig. 1

med

size

ON OFF

hot surface

Fig. 2

Fig. 3

Fig. 4

Fig. 5

timer