Atlantic A Series Producthandleiding - Pagina 2

Blader online of download pdf Producthandleiding voor {categorie_naam} Atlantic A Series. Atlantic A Series 16 pagina's.

Pagina afdrukken

Introduction

Thank you for choosing this Atlantic A-Series pump. Before using this pump please take a

moment to review this manual.

To avoid an accident do not use the pump in any way other than as described in this

manual. Please note the manufacturer cannot be responsible for accidents arising because

the product was not used as prescribed. After reading this manual keep it as a reference in

case questions arise during use. Using the pump in a manner that is not prescribed will void

the warranty.

Flow Chart (GPH)

MODEL

MAX FLOW

A-05

---

A-05L

---

A-21

---

A-31

---

AN-32

---

Recommended Operating Range

* Operating pumps outside of the recommended range may cause bearing damage and

premature failure.

Prior to Operation and Installation

When the pump is delivered, perform the following checks:

• Check for any damage to pump and power cable that may have occurred during the shipment.

• Check the model number to make sure it is the product that was ordered and verify the

voltage and frequency are correct.

Caution

• DO NOT operate this product under any condition other than those for which it is specified.

Failure to observe this precaution can lead to electrical shock or leakage, fire, water leakage

or other problems.

• A-05/A-05L/A-21/A-31 pumps require a single phase 115 volt / 60 hz power supply. A-32

pump requires a single phase 230 volt / 60 hz power supply. Always verify that the supplied

power meets the requirements listed on the upper pump cover.

• DO NOT apply any paint over the stainless steel motor body. Reduced cooling ability will

result in overheating, overloading, undesirable performance reductions, periodic auto

shut-off and pump malfunction.

• Never place your hand or any object in or near the inlet opening while this equipment is

operating. If pump inlet is clogged, always turn off the power supply, fuse box or circuit

breaker and wait until the motor is completely stopped before attempting to remove any

clogged material.

• Please make sure that the power plug and the AC outlet receptacle is protected and away

from water or pump discharge hose to prevent accidental electric shock or short circuit.

• Always operate the pump completely submerged in water.

• Avoid dry operation, which will not only lower performance but can cause the pump to

overheat/malfunction, leading to electrical leakage, shock or premature failure.

• CAUTION:

THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.

10'

15'

3165

2840

2500

5040

4320

3600

5810

5325

4824

9300

8150

6830

14100

13320

12300

Best Efficiency Range

20'

25'

30'

2155

1875

1455

2820

1920

840

4335

3770

3140

5535

4120

2535

11100

10200

9180

35'

40'

45'

935

320

2400

1530

540

625

7920

6600

5220

3900

Do Not Operate Range

50'

55'

60'

2520

1320