Atlantic A Series Producthandleiding - Pagina 3

Blader online of download pdf Producthandleiding voor {categorie_naam} Atlantic A Series. Atlantic A Series 16 pagina's.

• CAUTION:

THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.

Before You Start

• Check the model name plate to make sure once again that the product is of the correct

voltage and frequency rating.

• The setting on the circuit breaker or other overload protector should be made in accordance

with the rated currency of the pump.

• Turn off the power supply or circuit breaker before inserting the power supply plug to avoid

electrical shock, shorting, or unexpected starting of the pump, which could lead to injury.

• Never operate the pump while it is suspended in air. The recoil may result in injury or other

major accident.

Electrical Safety

• Electrical wiring should be installed by a qualified electrician in accordance with all

applicable safety regulations. Incorrect wiring can lead to a pump malfunction, electrical

shock or fire.

• Pumps should operate on a designated, circuit rated at 15 Amps (minimum).

• Pump must be protected by a ground fault circuit interrupter (GFCI).

• Pump must be plugged into a standard, properly grounded, three pronged outlet.

• Do not cut the electrical cable. If a cable with cut insulation or other damage is submerged

in water, there is danger of water seeping into the pump motor and causing a short. This

may result in damage to the pump, electrical shock or fire. Altering the electrical cable in

any way will void the warranty.

• Never move or handle the pump by pulling on the electrical cable. Make sure the electrical

cable does not become excessively bent or twisted, does not rub against a structure in a

way that might damage it, and does not come in contact with heated surfaces.

Operation

• In case of a power outage, turn off the power to the pump to avoid having it start

unexpectedly when the power is restored.

• Pay careful attention to the water level while the pump is operating. Dry operation may

cause the pump to malfunction. Pump must always operate while fully submersed.

• In case of very excessive vibration, unusual noise or odor, turn off the power immediately and

consult with your nearest dealer. Continuing to operate the pump under abnormal

conditions may result in electrical leakage, electrical shock or fire.

Motor Protection System

• The pump has a built-in motor protection system. The following situations may cause the

pump to stop automatically regardless of water level.

• Motor overheating

• Excessive current

• Change in voltage polarity

• Open-phase operation or operation under constraint

• Repeating cycles of stopping and restarting will damage the water pump. Do not

continue operation at low lift, low water level, or while the inlet is clogged with debris.

Not only will performance suffer, but also such conditions may cause noise, heavy

vibration, and pump failure.