AirTech SU-27 Flanker Gebruiksaanwijzing

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} AirTech SU-27 Flanker. AirTech SU-27 Flanker 2 pagina's.

Pagina afdrukken

Use this instruction Manual to get these Airtech planes assembled and into the air!

Replacement Parts.

If you need to, you can order replacement parts directly from us via telephone or email.

Please call (416) 444-6873 or send an email to [email protected]

Warranty

Interactive Toy Concepts guarantees your Stealth, Burner and Icer to be free from manufacturing defects. This warranty

does not cover any modifications or parts damaged by the owner. In no case will Interactive Toy Concepts' liability exceed

the original cost of the kit. Interactive Toy Concepts reserves the right to change this warranty without notice.

Interactive Toy Concepts assumes no liability over final assembly or for any damage resulting from the use of this product.

If the buyer is not prepared to accept the liability associated with the use of the aircraft, he/she should return it in unused

condition to the place of purchase.

We reserve the right to make improvements to the design of the airplane. Thus, your aircraft may vary slightly from that

depicted in the preceding photographs.

Battery Recycling & Disposal.

It may be illegal to dispose of the NiMH battery in your municipal waste. The battery pack contains a chemical known to

the State of California to cause birth defects or other reproductive problems. Do not try to open the battery pack!

Battery Care Information.

1) Never allow the battery pack to become hot during charging -This will cause permanent irreversible damage.

Warm is OK -HOT IS NOT!

2) Never leave a battery unattended while it is being charged.

3) Never leave a battery unattended in the presence of small children.

4) Charging time required for a full charge increases with the number of charge cycles due to the gradual draining of the

chargers "D" cells.

5) Never recharge a hot battery. Always allow it to cool before charging.

6) If you use an after-market charger, never charge the battery at a rate greater than 500mA.

7) If the flight battery is not completely discharged before recharging, the charging may be less than that of an "empty" battery.

Again, do not allow the battery to get too hot!

8) If a day or more passes without charging the battery, or if you are unsure whether or not it is fully charged, discharge the

battery, then fully recharge it.

9) Rechargeable batteries are to be removed from the toy before being charged (if removable).

10) Rechargeable batteries are only to be charged under adult supervision (if removable).

Troubleshooting.

If you are experiencing any problems with your Airtech aircraft, visit our website under the

Customer Service Tab -Troubleshooting Tips.

There you will find answers to many of your questions, supplied by our Airtech Flight Technicians.

FCC Note: USA only.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1) This device may not cause harmful interference. 2) This device must accept any interference received, including

interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This generates, uses and can radiate radio frequency energy and, if not installed and use in accordance

with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures: - Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver - Connect the

equipment into an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an experienced radio/TV technician for help.

Visit our website: www.interactivetoy.com to see

the complete line of Airtech R/C planes and indoor R/C Blimps!

PLEASE DO NOT RETURN THIS

PRODUCT TO ANY RETAIL STORE!

INFORMATION

Contact:

Interactive Toy Concepts Ltd.

1192 Martin Grove Road

Toronto, Ontario, Canada M9W 5M9

[email protected]

INSTRUCTION MANUAL

Use this Instruction Manual to get these Airtech planes assembled and into the air!

PRE-FLIGHT

Field Charger Preparation.

-Slide the cover off the charger

and install 6 D alkaline

batteries ensuring the polarities

are in the correct alignment.

Make sure to use new

Tip!

alkaline non-

rechargeable batteries for

best plane operation.

Flight Battery Charging.

-Locate the green NiMH flight

battery and plug it into the

charger. Note that the plugs

will only connect in one

orientation. Do not attempt to

force them together.

-Turn the timer dial on the

charger to the end of the

colored band. The timer will

count down and the charger

will shut off when the charge

is complete.

-Do not let the battery get too hot.

Warm is OK- HOT IS NOT!

Always allow the battery

Tip!

to completely discharge

in flight or on the ground before

charging again.

If unsure if a battery is

Tip!

charged or not, always

discharge before recharging.

Kit Includes: R/C plane, Quick Charger, Radio Control System, NiMH Battery, Wind Ribbon, Repair Kit and Instructions.

PLEASE DO NOT RETURN THIS

PRODUCT TO ANY RETAIL STORE!

Congratulations on the purchase of your Airtech R/C!

These planes are designed to fly great and be easy to

"learn how to fly". But remember, these are aircraft so

you must spend a bit of time reading through this manual

so you can learn what to do, and what not to do.

Look for these

Tip!

symbols for extra help!

Follow these easy steps to get your plane

ready to fly. Be sure to complete each step

correctly to ensure correct plane operation.

Install Transmitter Batteries.

-Remove the rear cover of the

transmitter and install 8 AA

alkaline batteries making sure

that the polarities are correct.

-Switch to ON, and ensure

that the red and green LEDs

light up.

IMPORTANT!

Switch Plane Off!

-Push the power switch on the

underside of the plane to the

off position.

-Always remember to shut your

plane "OFF" whenever it is

being charged, or not in use.

CAUTION:

Never turn "ON" the plane

when the transmitter is "OFF"!

Battery Installation.

-Push the 'catch' located on

the underside of the plane,

rearward and lift up. This will

release the battery cover.

-Plug the battery into the plane

and insert it into the

compartment. Close the cover.

For any questions or problems with this

product please call 1-866-214-2220.

Visit our website: www.interactivetoy.com

or E-mail us at [email protected]